M25P16 datasheet(27/39 Pages) STMICROELECTRONICS

27 / 39 page

27/39

M25P16

POWER-UP AND POWER-DOWN

At Power-up and Power-down, the device must

not be selected (that is Chip Select (S) must follow

the voltage applied on VCC) until VCC reaches the

correct value:

–VCC(min) at Power-up, and then for a further

delay of tVSL

–VSS at Power-down

Usually a simple pull-up resistor on Chip Select (S)

can be used to insure safe and proper Power-up

and Power-down.

To avoid data corruption and inadvertent write op-

erations during power up, a Power On Reset

(POR) circuit is included. The logic inside the de-

vice is held reset while VCC is less than the POR

threshold value, VWI – all operations are disabled,

and the device does not respond to any instruc-

tion.

Moreover, the device ignores all Write Enable

(WREN), Page Program (PP), Sector Erase (SE),

Bulk Erase (BE) and Write Status Register

(WRSR) instructions until a time delay of tPUW has

elapsed after the moment that VCC rises above the

VWI threshold. However, the correct operation of

the device is not guaranteed if, by this time, VCC is

still below VCC(min). No Write Status Register,

Program or Erase instructions should be sent until

the later of:

–tPUW after VCC passed the VWI threshold

–tVSL afterVCC passed the VCC(min) level

These values are specified in Table 8..

If the delay, tVSL, has elapsed, after VCC has risen

above VCC(min), the device can be selected for

READ instructions even if the tPUW delay is not yet

fully elapsed.

At Power-up, the device is in the following state:

–

The device is in the Standby mode (not the

Deep Power-down mode).

–

The Write Enable Latch (WEL) bit is reset.

Normal precautions must be taken for supply rail

decoupling, to stabilize the VCC feed. Each device

in a system should have the VCC rail decoupled by

a suitable capacitor close to the package pins.

(Generally, this capacitor is of the order of 0.1µF).

At Power-down, when VCC drops from the operat-

ing voltage, to below the POR threshold value,

VWI, all operations are disabled and the device

does not respond to any instruction. (The designer

needs to be aware that if a Power-down occurs

while a Write, Program or Erase cycle is in

progress, some data corruption can result.)

Figure 22. Power-up Timing

VCC

AI04009C

VCC(min)

VWI

Reset State

of the

Device

Chip Selection Not Allowed

Program, Erase and Write Commands are Rejected by the Device

tVSL

tPUW

time

Read Access allowed

Device fully

accessible

VCC(max)

M25P16 数据表(PDF) 27 Page - STMicroelectronics

M25P16 数据表(HTML) 27 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39

数据表下载