CS3.241

C-Line

13. EMC

The power supply is suitable for applications in industrial environment as well as in residential, commercial and light

industry environment.

A detailed EMC report is available on request.

EMC Immunity

According generic standards: EN 61000-6-1 and EN 61000-6-2

Electrostatic discharge

EN 61000-4-2

contact discharge

air discharge

8kV

15kV

Criterion A

Criterion A

Electromagnetic RF field

EN 61000-4-3

80MHz-2.7GHz

10V/m

Criterion A

Fast transients (Burst)

EN 61000-4-4

input lines

output lines

4kV

2kV

Criterion A

Criterion A

Surge voltage on input

EN 61000-4-5

L

N

L

PE, N

PE

2kV

4kV

Criterion A

Criterion A

Surge voltage on output

EN 61000-4-5

+

-

+ / -

PE

500V

1kV

Criterion A

Criterion A

Conducted disturbance

EN 61000-4-6

0.15-80MHz

10V

Criterion A

Mains voltage dips

EN 61000-4-11

0% of 100Vac

40% of 100Vac

70% of 100Vac

0% of 200Vac

40% of 200Vac

70% of 200Vac

0Vac, 20ms

40Vac, 200ms

70Vac, 500ms

0Vac, 20ms

80Vac, 200ms

140Vac, 500ms

Criterion B *)

Criterion C

Criterion A

Criterion A

Criterion A

Criterion A

Voltage interruptions

EN 61000-4-11

5000ms

Criterion C

Powerful transients

VDE 0160

over entire load range

750V, 1.3ms

Criterion A

Criterions:

A:

Power supply shows normal operation behavior within the defined limits.

B:

Temporary voltage dips possible. No change in operation mode.

C:

Temporary loss of function is possible. Power supply may shut-down and restarts by itself. No damage or hazards for the power supply

will occur.

*): Criterion A is fulfilled below 2.8A output current

EMC Emission

According generic standards: EN 61000-6-3, EN 61000-6-4

Conducted emission

input lines

EN 55011, EN 55022, FCC Part 15, CISPR 11, CISPR 22

Class B

Conducted emission

IEC/CISPR 16-1-2, IEC/CISPR 16-2-1

limits for DC power port

according EN 61000-6-3 not

fulfilled

Radiated emission

EN 55011, EN 55022

Class B

Harmonic input current

EN 61000-3-2

fulfilled

Voltage fluctuations, flicker

EN 61000-3-3

This device complies with FCC Part 15 rules.

Operation is subjected to following two conditions: (1) this device may not cause harmful interference, and (2) this

device must accept any interference received, including interference that may cause undesired operation.

*)

tested with constant current loads, non pulsing

**) for information only, not mandatory for EN 61000-6-3

Switching frequency

50kHz to 450kHz

Main converter, input voltage and load dependent

Jul. 2015 / Rev. 2.0 DS-CS3.241-EN

All parameters are specified at 24V, 3.3A, 230Vac, 50Hz, 25°C ambient and after a 5 minutes run-in time unless otherwise noted.

www.pulspower.com Phone +49 89 9278 0

Germany

13/24