QS10.DNET

Q-Series

Fig. 13-1 Front side

A

Input Terminals (Quick-connect spring-clamp terminals)

N, L

Line input

PE (Protective Earth) input

B

Output Terminals (Quick-connect spring-clamp terminals, two pins per

pole)

+

Positive output

–

Negative (return) output

C

DC-OK Relay Contact (Quick-connect spring-clamp terminals)

The DC-OK relay contact is synchronized with the DC-OK LED.

See chapter 8 for details.

D Output voltage potentiometer

Multi turn potentiometer;

Open the flap to adjust the output voltage. Factory set: 24.1V

E

DC-OK LED (green)

On, when the output voltage is >90% of the adjusted output voltage

F

Overload LED (red)

On, when the voltage on the output terminals is <90% of the adjusted

output voltage, or in case of a short circuit in the output.

Input voltage is required

Flashing, when the unit has switched off due to over-temperature.

Indicators, LEDs

Overload LED

DC-OK LED

DC-OK Contact

Normal mode

OFF

ON

Closed

OFF

ON

Closed

ON

OFF

Open

Output short circuit

ON

OFF

Open

Temperature Shut-down

Intermitted

OFF

Open

No input power

OFF

OFF

Open

Dec. 2014 / Rev. 2.2 DS-QS10.DNET-EN

All parameters are specified at 24V, 8A, 230Vac, 25°C ambient and after a 5 minutes run-in time unless otherwise noted.

www.pulspower.com Phone +49 89 9278 0

Germany

11/22