QS10.DNET

Q-Series

This bracket is used to mount the power

supply onto a flat surface without utilizing a

DIN-Rail.

This bracket is used to mount Dimension units sideways with or without utilizing a DIN-Rail. The two aluminum

brackets and the black plastic slider of the unit have to be detached, so that the steel brackets can be mounted.

For sideway DIN-rail mounting, the removed aluminum brackets and the black plastic slider need to be mounted on

the steel bracket.

Side mounting with DIN-rail brackets

Side mounting without DIN-rail brackets

This buffer unit is a supplementary device for DC 24V power supplies. It delivers power to bridge typical mains failures

or extends the hold-up time after turn-off of

the AC power. In times when the power

supply provides sufficient voltages, the buffer

unit stores energy in integrated electrolytic

capacitors. In case of mains voltage fault, this

energy is released again in a regulated

process. One buffer module can deliver 20A additional current.

DC

Buffer

Unit(s)

Power

Supply

Load

AC

+

-

The buffer unit does not require any control wiring. It can be added in parallel to the

load circuit at any given point. Buffer units can be added in parallel to increase the

output ampacity or the hold-up time.

Dec. 2014 / Rev. 2.2 DS-QS10.DNET-EN

All parameters are specified at 24V, 8A, 230Vac, 25°C ambient and after a 5 minutes run-in time unless otherwise noted.

www.pulspower.com Phone +49 89 9278 0

Germany

18/22