L99MD02 datasheet(27/46 Pages) STMICROELECTRONICS

27 / 46 page

L99MD02

Functional description of the SPI

Doc ID 16082 Rev 5

27/46

Figure 9.

Indication of the global error flag on SDO when CSN is low and SCK is stable

The bit 0 of the <Global Status Byte> is a combination of an under/overvoltage warning and

a software warning: If the bit 5 is one (this is the standard after a correct SPI

communication), bit 0 is the logical OR of all under- and overvoltage status bits.

On the other hand, if there has been an SPI communication error or a chip reset (bit 5 is

zero), then bit 0 gives a better indication about the SPI error: An SDI stuck-at error will lead

to a software reset and will set bit 0, while a clock pulse error only sets the communication

error bit, clears bit 5 and will clear also bit 0. This leads to the following table of possible

states (assuming there is no under/overvoltage, overcurrent, openload or thermal error):

Writing to the selected data input register is only enabled if exactly one frame length is

transmitted within one communication frame (i.e. CSN low). If more or less clock pulses are

counted within one frame, the complete frame will be ignored and a SPI frame error is

signaled in the Global Status register. This safety function is implemented to avoid an

unwanted activation of output stages by a wrong communication frame.

Table 21.

Reset

State

Description

Global status

EN = 0 (Power on reset)

All registers reset

Outputs switched off (3-state)

1000 0000

Clock cycles != 24

Ignore frame

No reset

1100 0000

SDI always 0

Software reset

Outputs switched off

1100 0001

SDI always 1

Software reset

Outputs switched off

1100 0001

L99MD02 数据表(PDF) 27 Page - STMicroelectronics

L99MD02 数据表(HTML) 27 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46

数据表下载