| 数据搜索系统,热门电子元器件搜索 |
|
STLED325 数据表(PDF) 30 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
STLED325 数据表(HTML) 30 Page - STMicroelectronics |
|
30 / 62 page ![]() Functional description STLED325 30/62 Doc ID 17576 Rev 1 spike is very low into the battery. The battery must be protected against such spikes. This is not relevant for super-cap. During the switching from VBAT to VCC, the I2C is active after a minimum of 5ms. 3.17.2 Battery low warning The STLED325 automatically performs battery voltage monitoring upon power-up. If the interrupt for this condition (ABE) is enabled, the RTC will generate an interrupt pulse if the battery voltage is found to be less than a minimum of 2.5V. However, this condition is unlikely to go away very quickly as time is needed for the battery to be replaced, and it is not desirable to keep issuing an interrupt. Therefore when this bit is set, this condition is checked once every week. If the condition is still true, then interrupt is sent again. The ABE bit is an enable bit for battery status check. If the ABE bit was set and the battery low is generated during a power up sequence, this indicates that the battery is below approximately 2.5 V and may not be able to maintain data integrity. At this point, a fresh battery needs to be installed or the super-cap recharged. This situation only occurs when a battery is used but not with a super-cap as the super-cap re-charges when the supply is present. 3.17.3 Different power operation modes The device is capable to support the different power modes as shown in the Table 8. Table 8. Different power operation modes VCC VBAT Condition Operation Present Present VCC > VBAT Normal operation of chip from VCC Present Absent (Float or 0V) VCC > VBAT and VCC > 3.5V Normal operation of chip from VCC until VCC is 3.5V Absent (Float or 0V) Present VBAT > 2.5V Chip operations from VBAT in a low power mode of operation VCC < 3.5V VBAT > VCC Chip operations from VBAT in a low power mode of operation Absent (Float or 0V) Absent (Float or 0V) VCC < 3.5V and VBAT < 2.5V Chip does not function. Completely shutdown. |
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |