7782 datasheet(30/63 Pages) STMICROELECTRONICS

30 / 63 page

M58CR032C, M58CR032D

30/63

been issued and the memory is waiting for a Pro-

gram/Erase Resume command. The Program

Suspend Status should only be considered valid

when the Program/Erase Controller Status bit is

High (Program/Erase Controller inactive). Bit 2 is

set within 5µs of the Program/Erase Suspend

command being issued therefore the memory may

still complete the operation rather than entering

the Suspend mode.

When a Program/Erase Resume command is is-

sued the Program Suspend Status bit returns Low.

Block Protection Status (Bit 1). The Block Pro-

tection Status bit can be used to identify if a Pro-

gram or Erase operation has tried to modify the

contents of a locked block.

When the Block Protection Status bit is High (set

to ‘1’), a Program or Erase operation has been at-

tempted on a locked block.

Once set High, the Block Protection Status bit can

only be reset Low by a Clear Status Register com-

mand or a hardware reset. If set High it should be

reset before a new command is issued, otherwise

the new command will appear to fail.

Reserved (Bit 0). Bit 0 of the Status Register is

reserved. Its value must be masked.

Note: Refer to Appendix B, Flowcharts and

Pseudo Codes, for using the Status Register.

Table 15. Status Register Bits

Note: Logic level ’1’ is High, ’0’ is Low.

Bit

Name

Logic Level

Definition

P/E.C. Status

’1’

Ready

’0’

Busy

Erase Suspend Status

’1’

Suspended

’0’

In progress or Completed

Erase Status

’1’

Erase Error

’0’

Erase Success

Program Status

’1’

Program Error

’0’

Program Success

VPP Status

’1’

VPP Invalid, Abort

’0’

VPP OK

Program Suspend Status

’1’

Suspended

’0’

In Progress or Completed

Block Protection Status

’1’

Program/Erase on protected Block, Abort

’0’

No operation to protected blocks

Reserved

7782 数据表(PDF) 30 Page - STMicroelectronics

7782 数据表(HTML) 30 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63

数据表下载