WM8912 datasheet(36/129 Pages) CIRRUS

36 / 129 page

WM8912

Production Data

PD, Rev 4.1, February 2013

DAC SLOPING STOPBAND FILTER

Two DAC filter types are available, selected by the register bit DAC_SB_FILT. When operating at

lower sample rates (e.g. during voice communication) it is recommended that the sloping stopband

filter type is selected (DAC_SB_FILT=1) to reduce out-of-band noise which can be audible at low

DAC sample rates. See “Digital Filter Characteristics” for details of DAC filter characteristics.

ADDRESS

BIT

LABEL

DEFAULT

DESCRIPTION

R33 (21h)

DAC Digital 1

DAC_SB_FILT

Selects DAC filter characteristics

0 = Normal mode

1 = Sloping stopband mode

Table 21 DAC Sloping Stopband Filter

DAC OVERSAMPLING RATIO (OSR)

The DAC oversampling rate is programmable to allow power consumption versus audio performance

trade-offs. The default oversampling rate is low for reduced power consumption; using the higher

OSR setting improves the DAC signal-to-noise performance.

ADDRESS

BIT

LABEL

DEFAULT

DESCRIPTION

R33 (21h)

DAC Digital 1

DAC_OSR128

DAC Oversample Rate Select

0 = Low power (normal OSR)

1 = High performance (double OSR)

Table 22 DAC Oversampling Control

WM8912 数据表(PDF) 36 Page - Cirrus Logic

WM8912 数据表(HTML) 36 Page - Cirrus Logic

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载