VS6552V02CSLASHT2 datasheet(8/26 Pages) STMICROELECTRONICS

8 / 26 page

VS6552

8/26

Figure 3. VS6552 Power-up Sequence

3.4.2 Active Signals with Unpowered VS6552

All signals going into the VS6552 must be either at

a low state or high impedance when power is re-

moved from the device. The exceptions to this rule

are the I2C lines which may be at a low or high

state and the clock which can be active.

3.5 Clock and Frame Rate Timing

3.5.1 Video Frame Rate Control

The output frame rate of VS6552 can be reduced

by extending the frame length. The extension is

achieved by adding 'blank' video lines to act as

timing padding. This is advantageous as it does

not reduce the pixel readout rate and therefore

does not introduce unwanted motion distribution

effects to the image. The frame rate can be re-

duced from the default 30 frame/s at VGA resolu-

tion to less than 3 frame/s at VGA resolution.

3.5.2 PLL and Clock Input

A PLL IP block is embedded. This block generates

all necessary internal clocks from an input range

defined in Table 5. The input clock pad accepts up

to 26 MHz signals.

Table 5. System Input Clock Frequency Range

3.5.3 Clock Input Type

VS6552 can receive the following clock types:

■ Single ended CMOS

■ Single ended Sine wave

■ Clock can be AC or DC coupled

The clock is fail-safe.

PDN

CLK

AVDD (2.8V)

VDD (1.8V)

MSDA

MSCL

Mode Change: Clock active -> Idle

Clock active

Standby

Idle

Sleep

Streaming

PCLKP/N

PDATAP/N

Mode Change: Sleep -> Clock active

Mode Command: Idle -> Streaming

also enable data output

and enable data qualification clock and

general configuration

System clock frequencya

a.The standard supported input frequencies (in MHz) are as

follows: 6.5, 8.4, 9, 9.6, 9.72, 12,13, 16.8, 18, 19.2,

19.44, 26.

Min. (MHz)

Max. (MHz)

6.5

VS6552V02C/T2 数据表(PDF) 8 Page - STMicroelectronics

VS6552V02C/T2 数据表(HTML) 8 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26

数据表下载