ATSAMB11XR datasheet(78/87 Pages) MICROCHIP

78 / 87 page

certification number of the module, preceded by the words “Contains”, or similar wording expressing the

same meaning, as follows:

For the ATSAMB11-ZR210CA:

Contains IC: 20266-SAMB11ZR

User Manual Notice for License-Exempt Radio Apparatus (from Section 8.4 RSS-Gen, Issue 4,

November 2014): User manuals for license-exempt radio apparatus shall contain the following or

equivalent notice in a conspicuous location in the user manual or alternatively on the device or both:

This device complies with Industry Canada’s license exempt RSS standard(s). Operation is

subject to the following two conditions:

(1) This device may not cause interference, and

(2) This device must accept any interference, including interference that may cause undesired

operation of the device.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio

exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:

(1) l'appareil ne doit pas produire de brouillage, et

(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le

brouillage est susceptible d'en compromettre le fonctionnement.

Guidelines on Transmitter Antenna for License Exempt Radio Apparatus:

Under Industry Canada regulations, this radio transmitter may only operate using an antenna of

a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce

potential radio interference to other users, the antenna type and its gain should be so chosen

that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for

successful communication.

Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peut

fonctionner avec une antenne d'un type et d'un gain maximal (ou inférieur) approuvé pour

l'émetteur par Industrie Canada. Dans le but de réduire les risques de brouillage radioélectrique

à l'intention des autres utilisateurs, il faut choisir le type d'antenne et son gain de sorte que la

puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas l'intensité nécessaire à

l'établisse-ment d'une communication satisfaisante.

16.2.2

RF Exposure

All transmitters regulated by Innovation, Science and Economic Development Canada (ISED) must

comply with RF exposure requirements listed in RSS-102 - Radio Frequency (RF) Exposure Compliance

of Radio communication Apparatus (All Frequency Bands).

This transmitter is restricted for use with a specific antenna tested in this application for certification, and

must not be co-located or operating in conjunction with any other antenna or transmitters within a host

device, except in accordance with Canada multi-transmitter product procedures.

The device operates at an output power level which is within the ISED SAR test exemption limits at any

user distance.

16.2.3

Helpful Web Sites

Innovation, Science and Economic Development Canada: http://www.ic.gc.ca/

ATSAMB11XR/ZR

Datasheet Preliminary

DS70005342A-page 78

ATSAMB11XR 数据表(PDF) 78 Page - Microchip Technology

ATSAMB11XR 数据表(HTML) 78 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87

数据表下载