HMC6832

Data Sheet

Rev. C | Page 22 of 23

EVALUATION PRINTED CIRCUIT BOARD (PCB)

An easy to use evaluation PCB is available from Analog Devices

upon request. Top and bottom view layouts of the evaluation

board are given in Figure 54 and Figure 55. For the circuit board

in this application, use RF circuit design techniques.

Ensure that signal lines have 50 Ω impedance. Connect the

package ground leads and exposed paddle directly to the

ground plane similarly to that shown in Figure 54 (top view)

and Figure 55 (bottom view). Use a sufficient number of via

holes to connect the top and bottom ground planes.

Figure 54. Evaluation PCB (Top View)

Figure 55. Evaluation PCB (Bottom View)