GD25B127DFES datasheet(36/65 Pages) GIGADEVICE

36 / 65 page

3.3V Uniform Sector

Dual and Quad Serial Flash

GD25B127D

7.26.

Program/Erase Suspend (PES) (75H)

The Program/Erase Suspend command

“75H”, allows the system to interrupt a page program or sector/block erase

operation and then read data from any other sector or block. The Write Status Register command (01H/31H/11H) and

Erase/Program Security Registers command (44H,42H) and Erase commands (20H, 52H, D8H, C7H, 60H) and Page

Program command (02H / 32H) are not allowed during Program suspend. The Write Status Register command

(01H/31H/11H) and Erase Security Registers command (44H) and Erase commands (20H, 52H, D8H, C7H, 60H) are not

allowed during Erase suspend. Program/Erase Suspend is valid only during the page program or sector/block erase

operation. A maximum of

time of “tsus” (See AC Characteristics) is required to suspend the program/erase operation.

The Program/Erase Suspend command will be accepted by the device only if the SUS2/SUS1 bit in the Status Register

equal to 0 and WIP bit equal to 1 while a Page Program or a Sector or Block Erase operation is on-going. If the SUS2/SUS1

bit equal to 1 or WIP bit equal to 0, the Suspend command will be ignored by the device. The WIP bit will be cleared from 1

to 0 within “tsus” and the SUS2/SUS1 bit will be set from 0 to 1 immediately after Program/Erase Suspend. A power-off

during the suspend period will reset the device and release the suspend state. The command sequence is show in Figure29.

Figure29. Program/Erase Suspend Sequence Diagram

7.27.

Program/Erase Resume (PER) (7AH)

The Program/Erase Resume command must be written to resume the program or sector/block erase operation after

a Program/Erase Suspend command. The Program/Erase command will be accepted by the device only if the SUS2/SUS1

bit equal to 1 and the WIP bit equal to 0. After issued the SUS2/SUS1 bit in the status register will be cleared from 1 to 0

immediately, the WIP bit will be set from 0 to 1 within 200ns and the Sector or Block will complete the erase operation or

the page will complete the program operation. The Program/Erase Resume command will be ignored unless a

Program/Erase Suspend is active. The command sequence is show in Figure30.

Figure30. Program/Erase Resume Sequence Diagram

Command

75H

CS#

SCLK

High-Z

tSUS

Accept read command

Command

7AH

CS#

SCLK

Resume Erase/Program

GD25B127DFES 数据表(PDF) 36 Page - GigaDevice Semiconductor (Beijing) Inc.

GD25B127DFES 数据表(HTML) 36 Page - GigaDevice Semiconductor (Beijing) Inc.

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65

数据表下载