Uniform Sector

Standard and Dual Serial Flash

GD25WD80C

14

7.3. Read Status Register (RDSR) (05H)

The Read Status Register (RDSR) command is for reading the Status Register. The Status Register may be read at

any time, even while a Program, Erase or Write Status Register cycle is in progress.

When one of these cycles is in progress, it is recommended to check the Write In Progress (WIP) bit before sending

a new command to the device. It is also possible to read the Status Register cont

inuously. For command code “05H”, the

SO will output Status Register bits S7~S0.

Figure3. Read Status Register Sequence Diagram

7.4. Write Status Register (WRSR) (01H)

The Write Status Register (WRSR) instruction allows new values to be written to the Status Register. A Write Enable

(WREN) instruction must be executed previously to set the Write Enable Latch (WEL) bit, before it can be accepted.

The Write Status Register (WRSR) instruction is entered by driving Chip Select (CS#) Low, followed by the instruction

code and the data byte on Serial Data Input (SI).

The Write Status Register (WRSR) instruction has no effect on S6, S5, S1 and S0 of the Status Register. S6 and S5

are always read as 0. Chip Select (CS#) must be driven High after the eighth bit of the data byte has been latched in.

Otherwise, the Write Status Register (WRSR) instruction is not executed. As soon as Chip Select (CS#) is driven High, the

self-timed Write Status Register cycle (the duration is tW) is initiated. While the Write Status Register cycle is in progress,

reading Status Register to check the Write In Progress (WIP) bit is achievable.

The Write In Progress (WIP) bit is 1 during the self-timed Write Status Register cycle, and turn to 0 on the completion

of the Write Status Register. When the cycle is completed, the Write Enable Latch (WEL) is reset to 0.

The Write Status Register (WRSR) instruction allows the user to change the values of the Block Protect (BP2, BP1,

BP0) bits, which are utilized to define the size of the read-only area.

The Write Status Register (WRSR) instruction also allows the user to set or reset the Status Register Protect (SRP)

bit in accordance with the Write Protect (WP#) signal, by setting which the device can enter into Hardware Protected Mode

(HPM). The Write Status Register (WRSR) instruction is not executed once enter into the Hardware Protected Mode (HPM).

Figure4. Write Status Register Sequence Diagram

Command

0

1

2

3

4

5

6

7

05H

CS#

SCLK

SI

SO

High-Z

8

9 10 11 12 13 14 15

7

6

5

4

3

2

1

0

7

6

5

4

3

2

1

0

7

MSB

S7~S0 out

S7~S0 out

MSB

Command

0

1

2

3

4

5

6

7

01H

CS#

SCLK

SI

SO

High-Z

8

9 10 11 12 13 14 15

MSB

7

6

5

4

3

2

1

0

Status Register in