| 数据搜索系统,热门电子元器件搜索 |
|
BLUENRG-LP 数据表(PDF) 12 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
BLUENRG-LP 数据表(HTML) 12 Page - STMicroelectronics |
|
12 / 72 page ![]() 1.6.4 Power supply supervisor The BlueNRG-LP device embeds several power voltage monitoring: • Power-on-reset (POR): during the power-on, the device remains in reset mode if VDDIO is below a VPOR threshold (typically 1.65 V) • Power-down-reset (PDR): during power-down, the PDR puts the device under reset when the supply voltage (VDD) drops below the VPDR threshold (around 20 mV below VPOR). The PDR feature is always enabled • Power voltage detector (PVD): can be used to monitor the VDDIO (against a programmed threshold) or an external analog input signal. When the feature is enabled and the PVD measures a voltage below the comparator, an interrupt is generated (if unmasked) 1.7 Operating modes Several operating modes are defined for the BlueNRG-LP: • RUN mode • DEEPSTOP mode • SHUTDOWN mode Table 2. Relationship between the low power modes and functional blocks Mode SHUTDOWN DEEPSTOP IDLE RUN CPU OFF OFF OFF ON Flash OFF OFF ON ON RAM OFF ON/OFF granularity 16 kB ON/OFF ON/OFF Radio OFF OFF ON/OFF ON/OFF Supply system OFF OFF ON ( DC-DC ON/OFF) ON ( DC-DC ON/OFF) Register retention OFF ON ON ON HS clock OFF OFF ON ON LS clock OFF ON/OFF ON ON Peripherals OFF OFF ON/OFF ON/OFF Wake-on RTC OFF ON/OFF ON/OFF NA Wake-on GPIOs OFF ON/OFF ON/OFF NA Wake-on reset pin ON ON ON NA 1.7.1 RUN mode In RUN mode the BlueNRG-LP is fully operational: • All interfaces are active • The internal power supplies are active • The system clock and the bus clock are running • The CPU core and the radio can be used The power consumption may be reduced by gating the clock of the unused peripherals. 1.7.2 DEEPSTOP mode The DEEPSTOP is the only low power mode of the BlueNRG-LP allowing the restart from a saved context environment and the application at wake-up to go on running. The conditions to enter the DEEPSTOP mode are: • The radio is sleeping (no radio activity) • The CPU is sleeping (WFI with SLEEPDEEP bit activated) • No unmasked wake-up sources are active • The low power mode selection (LPMS) bit of the power controller unit is 0 (default) BlueNRG-LP Operating modes DS13282 - Rev 2 page 12/72 |
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |