AD4022BCPZ-R2 datasheet(34/39 Pages) AD

34 / 39 page

AD4020/AD4021/AD4022

Data Sheet

Rev. B | Page 34 of 40

CS MODE, 4-WIRE WITHOUT THE BUSY INDICATOR

This mode is typically used when multiple AD4020/AD4021/

AD4022 devices are connected to an SPI-compatible digital

host. A connection diagram using two AD4020/AD4021/AD4022

devices is shown in Figure 61, and the corresponding timing

diagram is shown in Figure 62.

Turbo mode must be disabled to use this mode. To disable turbo

mode, set the turbo mode enable bit in the configuration

A rising edge on CNV initiates a conversion and forces SDO to

high impedance. When performing conversions in this mode,

SDI must be high during the CNV rising edge. CNV must be

held high throughout the conversion and data readback phase.

When performing conversions in this mode, SDI must be high

during the CNV rising edge. Prior to the minimum conversion

time (tCONV), SDI can select other SPI devices, such as analog

multiplexers. However, SDI must be returned high before the

minimum conversion time elapses and then held high for the

maximum possible conversion time to avoid generating the

busy signal indicator. When the conversion is complete, the

AD4020/AD4021/AD4022 enter the acquisition phase and

power down. There must not be any digital activity on SCK

during the conversion.

SDI is analogous to a chip select input and each ADC result can

be read by bringing the corresponding SDI input low. Bringing

SDI low on each device outputs the MSB of the conversion

result on the corresponding SDO pin. The remaining data bits

are clocked out on SDO by subsequent SCK falling edges. The

data is valid on both SCK edges. The conversion result is clocked

out on SDO on the first 20 SCK falling edges. If the status bits

are enabled, they are shifted out on SDO on the 21st through the

26th SCK falling edges (see the Status Bits section). SDO returns to

high impedance after the final SCK falling edge, or when SDI goes

high (whichever occurs first). If the SDO of each device is tied

together, ensure SDI is only low for one device at a time. The

user must also provide a delay of tQUIET2 between the final SCK

falling edge and the next CNV rising edge to ensure specified

performance.

AD4020/

AD4021/

AD4022

SDI

SDO

CNV

SCK

AD4020/

AD4021/

AD4022

SDI

SDO

CNV

SCK

DEVICE B

DEVICE A

CONVERT

DATA IN

CLK

DIGITAL HOST

CS1

CS2

Figure

61. CS Mode, 4-Wire Without Busy Indicator Connection Diagram

SDO

D19

D18

D17

tDIS

SCK

tHSDO

tDSDO

tEN

CONVERSION

ACQUISITION

tCONV

CYC

tACQ

ACQUISITION

SDI(CS1)

CNV

tSSDICNV

tHSDICNV

tSCK

tSCKL

tSCKH

D19

D18

SDI(CS2)

tQUIET2

Figure

62. CS Mode, 4-Wire Without the Busy Indicator Serial Interface Timing Diagram (Status Bits Not Shown)

AD4022BCPZ-R2 数据表(PDF) 34 Page - Analog Devices

AD4022BCPZ-R2 数据表(HTML) 34 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39

数据表下载