ADIS16IMU1SLASHPCBZ datasheet(36/38 Pages) AD

36 / 38 page

ADIS16486

Data Sheet

Rev. 0 | Page 36 of 38

APPLICATIONS INFORMATION

MOUNTING BEST PRACTICES

For the best performance, follow these rules when installing the

ADIS16486 into a system:

•

Eliminate the opportunity for translational force (x-axis

and y-axis direction, per Figure 18) application on the

electrical connector.

•

Isolate the mounting force to the four corners on the

portion of the package surface that surrounds the

mounting holes.

•

Use uniform mounting forces on all four corners. The

suggested torque setting is 40 inch ounces (0.285 Nm).

These three rules help prevent irregular force profiles that can

warp the package and introduce bias errors in the sensors.

Figure 33 provides an example that leverages washers to set the

package off the mounting surface and uses 2.85 mm passthrough

holes and backside washers and nuts for attachment. Figure 31

and Figure 32 provide details for mounting hole and connector

alignment pin drill locations.

For more information on mounting the ADIS16486, see the

AN-1295 Application Note.

DEVICE

OUTLINE

19.800 BSC

39.600 BSC

5 BSC

NOTES

1. ALL DIMENSIONS IN mm UNITS.

2. IN THIS CONFIGURATION, THE CONNECTOR IS FACING DOWN AND

ITS PINS ARE NOT VISIBLE.

0.560 BSC 2×

ALIGNMENT HOLES

PASSTHROUGH HOLE

FOR MOUNTING SCREWS

DIAMETER OF THE HOLE

MUST ACCOMODATE

DIMENSIONAL TOLERANCE

BETWEEN THE CONNECTOR

AND HOLES.

FOR MATING SOCKET

Figure 31. Suggested PCB Layout Pattern, Connector Down

0.4334 [11.0]

0.0240 [0.610]

0.019685

[0.5000]

(TYP)

0.054 [1.37]

0.0394 [1.00]

0.1800

[4.57]

NONPLATED

THRU HOLE 2×

0.022±

DIA (TYP)

0.022 DIA THRU HOLE (TYP)

NONPLATED THRU HOLE

Figure 32. Suggested Layout and Mechanical Design When Using

Samtec CLM-112-02-G-D-A for the Mating Connector

MOUNTING SCREWS

M2 × 0.4mm, 4×

WASHERS (OPTIONAL)

M2, 4×

ADIS16486

WASHERS (OPTIONAL)

M2, 4×

NUTS

M2 × 0.4mm, 4×

MATING CONNECTOR

CLM-112-02

PCB

PASS-THROUGH HOLES

DIAMETER

≥ 2.85mm

SPACERS/WASHERS

SUGGESTED, 4×

Figure 33. Mounting Example

ADIS16IMU1/PCBZ 数据表(PDF) 36 Page - Analog Devices

ADIS16IMU1/PCBZ 数据表(HTML) 36 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38

数据表下载