7.4

RPDS_L (18h)

Pressure offset (LSB data)

7

6

5

4

3

2

1

0

RPDS7

RPDS6

RPDS5

RPDS4

RPDS3

RPDS2

RPDS1

RPDS0

RPDS[7:0]

This register contains the low part of the pressure offset value.

If, after the soldering of the component, a residual offset is still present, it can be removed with a one-point

calibration.

After soldering, the measured offset can be stored in the RPDS_H (19h) and RPDS_L (18h) registers and

automatically subtracted from the pressure output registers: the output pressure register PRESS_OUT (28h, 29h

and 2Ah) is provided as the difference between the measured pressure and the content of the register 256*RPDS

(18h, 19h).

7.5

RPDS_H (19h)

Pressure offset (MSB data)

7

6

5

4

3

2

1

0

RPDS15

RPDS14

RPDS13

RPDS12

RPDS11

RPDS10

RPDS9

RPDS8

RPDS[15:8]

This register contains the high part of the pressure offset value. Refer to RPDS_L (18h).

7.6

RES_CONF (1Ah)

Low-power mode configuration

7

6

5

4

3

2

1

0

0(1)

0(1)

0(1)

0(1)

0(1)

0(1)

reserved(2)

LC_EN

1. This bit must be set to ‘0’ for proper operation of the device.

2. The content of this bit must not be modified for proper operation of the device.

LC_EN(1)

Low-current mode enable. Default: 0

(0: normal mode (low-noise mode); 1: low-current mode).

1. The LC_EN bit must be changed only with the device in power down and not during operation. Once the LC_EN bit is

configured, it affects both One-shot mode and Continuous mode.

LPS33K

RPDS_L (18h)

DS12817 - Rev 3

page 19/31