A22Z-R datasheet(44/52 Pages) OMRON

44 / 52 page

A22E

Installing/Replacing the LED Lamp

Control Box (Enclosure)

Installing/Removing the Switch Blocks

Wiring

Installing/Replacing on the Switch

• Grip the lamp with your fingers, then rotate the lamp while pressing it against the Switch.

(1) Mounting the Switch

(2) Creating a Cable Port Hole

(3) Securing the Connector Cable

The Standard-size Legend Plate Frame can

be mounted.

Mount the Frame as shown in the following

diagram. Mount the Switch in the same way

as for an ordinary panel.

Place the tip of a screwdriver on the surface

where the cable port hole is to be created

with the cover attached and strike the

screwdriver to punch a hole.

Attempts to punch a hole on the other side

of the case will damage the Box.

1. Insert the connector into the cable port hole in the Box and secure

with the Mounting Ring inside the box.

2. Pass the tightening cap through the cable, insert the cable into the

connector, and tighten the tightening cap to secure the cable.

(1) Installing the Switch Blocks

(2) Removing the Switch Blocks

Wiring Round Crimp Terminals

• Hook the small protrusion on the Mounting Latch

into the groove on the other side of the lever, then

push up the Switch Block in the direction indicated

by the arrow in the figure below.

• Insert a screwdriver between the Mounting Latch

and the Switch Block, then push down the screw-

driver in the direction indicated by the arrow in the

following figure.

• Loosen the terminal screw from the Switch

Unit until it completely comes off the groove,

insert a screwdriver as shown in the following

figure, then push up the washer in the direc-

tion indicated by the arrow to temporarily

secure it.

Now, a round crimp terminal can be con-

nected. After inserting the terminal, tighten the

screws to complete wiring.

Snap-in Legend Plate

Cable diameter (mm)

Connector

7 to 9 dia.

A22Z-3500-1

9 to 11 dia.

A22Z-3500-2

Box

Connector

Tightening cap

Cable

O Ring

Fixing

Ring

Switch Blocks

Mounting Latches

Lever

Protrusion

Screwdriver

Use either of the following screwdrivers.

Flat-head screwdriver

3 to 6 mm

3 to 6 mm dia.

Phillips screwdriver

Screwdriver

Washer

Screw

A22Z-R 数据表(PDF) 44 Page - Omron Electronics LLC

A22Z-R 数据表(HTML) 44 Page - Omron Electronics LLC

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52

数据表下载