L9780 datasheet(35/56 Pages) STMICROELECTRONICS

35 / 56 page

DocID026356 Rev 3

35/56

L9780

Digital interface description

the beginning of the new measurement cycle. COMPSEL bit value reported in the output

For correct use of this bit, refer also to Section 5.5.3.

Default state for this bit after power on reset: 0.

Bit 50: CLAMPEN

This bit enables (CLAMPEN=’1’) or disables (CLAMPEN=’0’) VCCS voltage clamp.

If the device receives an SPI command in order to modify CLAMPEN bit in the middle of a

measurement cycle, it stores the new information and applies it at the beginning of the new

measurement cycle. CLAMPEN bit value reported in the output register is the value used in

the last measurement cycle.

Default state for this bit after power on reset: 0.

Bit 49: CLAMPCL

This bit selects the clamp voltage input pin as follows:

CLAMPCL=’0’ => selected pin CL1;

CLAMPCL=’1’ => selected pin CL2.

If the device receives an SPI command in order to modify CLAMPCL bit in the middle of a

measurement cycle while VCCS is disabled, it stores the new information and applies it at

the beginning of the new measurement cycle. CLAMPCL bit value reported in the output

For correct use of this bit, refer also to Section 5.5.3.

Default state for this bit after power on reset: 0

Bit 48: CLAMPSIM

This bit selects symmetric or asymmetric voltage clamp limit range as follows:

CLAMPSIM=’0’ => symmetric clamp limit range;

CLAMPSIM=’1’ => asymmetric clamp limit range.

For the meaning of symmetric/asymmetric range refer to VCCS analog description in

section 5.9.

If the device receives an SPI command in order to modify CLAMPSIM bit in the middle of a

measurement cycle while VCCS is disabled, it stores the new information and applies it at

the beginning of the new measurement cycle. CLAMPSIM bit value reported in the output

For correct use of this bit, refer also to Section 5.5.3.

Default state for this bit after power on reset: 0

Bit 47: CLEARFLT

This bit is used to clear latched faults when the origin of the fault is removed, as follows:

CLEARFLT=’0’ => no action;

CLEARFLT=’1’ => clears faults after CSN bit returns to ‘1’.

L9780 数据表(PDF) 35 Page - STMicroelectronics

L9780 数据表(HTML) 35 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56

数据表下载

链接网址

L9780 数据表(PDF) 35 Page - STMicroelectronics

L9780 数据表(HTML) 35 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56

数据表 下载

链接网址

数据表下载