| 数据搜索系统,热门电子元器件搜索 |
|
TMPR4955AF 数据表(PDF) 94 Page - Toshiba Semiconductor |
|
|
|||||||||||||||||||||||||||||
TMPR4955AF 数据表(HTML) 94 Page - Toshiba Semiconductor |
|
94 / 168 page ![]() Chapter 6 TX4955A System Interface 6-22 6.2.8.11 Read response protocol The external agent must use the read response protocol to return data to the processor if a processor read request has been received. The sequence of the read response protocol is as follows. 1. The external agent waits for the processor to automatically execute a shift into the slave state. 2. The external agent uses either a single data cycle or a series of data cycles to return data. 3. After issuing the final data cycle, the read response ends, then the external agent sets the SysCmd and SysAD busses to tri-state. 4. The system interface returns to the master state. Note: After issuing a read response, the processor automatically shifts to the slave state. 5. Data identifiers of a data cycle must indicate that the data are response data. 6. Final data cycle identifiers must contain an indication that a cycle is the final data cycle. In the case of read responses to non-coherent block read requests, it is not necessary for the response data to check the initial cache state. The cache state is automatically set to exclusively dirty. Data identifiers of data cycles can send notification of transfer data errors in those cycles. The external agent must return data blocks with the correct size even when there is an error in the data. Whether there is a single error or multiple errors in the read response data cycles, the processor processes them as bus errors. Read responses must always be returned to the processor when a processor read request is being held. Processor operation is not defined if a read response was returned in a state where there were no processor read requests on hold. Figure 6.2.22 illustrates a processor word read request and the subsequent word read response. Also, Figure 6.2.23 illustrates the read response to a processor block read request when the system interface is in the slave state. Note: The SysADC bus and SysCmdP bus timing is the same as the SysAD bus and SysCmd timing, respectively. |
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |