AT89LP213 datasheet(36/90 Pages) ATMEL

36 / 90 page

3538A–MICRO–7/06

AT89LP213/214 [Preliminary]

15. External Interrupts

When the AT89LP213/214 is configured to use the internal RC Oscillator, XTAL1 and XTAL2

may be used as the INT0 and INT1 external interrupt sources. The external interrupts can be

programmed to be level-activated or transition-activated by setting or clearing bit IT1 or IT0 in

ITx = 1, external interrupt x is edge-triggered. In this mode if successive samples of the INTx pin

show a high in one cycle and a low in the next cycle, interrupt request flag IEx in TCON is set.

Flag bit IEx then requests the interrupt. Since the external interrupt pins are sampled once each

clock cycle, an input high or low should hold for at least 2 oscillator periods to ensure sampling.

If the external interrupt is transition-activated, the external source has to hold the request pin

high for at least two clock cycles, and then hold it low for at least two clock cycles to ensure that

the transition is seen so that interrupt request flag IEx will be set. IEx will be automatically

cleared by the CPU when the service routine is called if generated in edge-triggered mode. If the

external interrupt is level-activated, the external source has to hold the request active until the

requested interrupt is actually generated. Then the external source must deactivate the request

before the interrupt service routine is completed, or else another interrupt will be generated.

16. General-purpose Interrupts

The General-purpose Interrupt (GPI) function provides 8 configurable external interrupts on

Port 1. Each port pin can detect high/low levels or positive/negative edges. The GPIEN register

select which bits of Port 1 are enabled to generate an interrupt. The GPMOD and GPLS regis-

ters determine the mode for each individual pin. GPMOD selects between level-sensitive and

edge-triggered mode. GPLS selects between high/low in level mode and positive/negative in

edge mode. The pins of Port 1 are sampled every clock cycle. In level-sensitive mode, a valid

level must appear in two successive samples before generating the interrupt. In edge-triggered

mode, a transition will be detected if the value changes from one sample to the next. When an

interrupt condition on a pin is detected, and that pin is enabled, the appropriate flag in the GPIF

Table 16-1.

GPMOD

– General-purpose Interrupt Mode Register

GPMOD = 9AH

Reset Value = 0000 0000B

Not Bit Addressable

GPMOD7

GPMOD6

GPMOD5

GPMOD4

GPMOD3

GPMOD2

GPMOD1

GPMOD0

Bit

543

GPMOD.x

0 = level-sensitive interrupt for P1.x

1 = edge-triggered interrupt for P1.x

AT89LP213 数据表(PDF) 36 Page - ATMEL Corporation

AT89LP213 数据表(HTML) 36 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90

数据表下载