Dimensions are shown in mm (inch)

Dimensions subject to change

126

RF Coaxial Connectors

Assembly Instructions

AI-755

MCX Right Angle Connectors, Direct Solder Type for Times T - Flex Cable

1. Dip 9,50 (.374) to 12,70 (.500) of both ends of the cable into a solder pot. Flux may be applied to

the ends of the cable prior to dipping, if desired.

2. Trim cable to dimensions shown being careful not to nick the center conductor or braid. Trim

center conductor (DO NOT OVER TIN).

3. Orientate slot of contact and insulator to be parallel to the cable entry hole as shown.

4. Push cable into body and solder in place.

5. Solder center conductor to center contact (do not over solder).

6. Insert insulation disc (if supplied), into bore then dimple or lightly punch cap into counterbore until

fully home.

7. Install shrink tubing as shown, apply indirect heat to shrink the tubing down.

CAP

INSULATION DISC

BODY ASSEMBLY

AB

2,29 (.090)

3,69 (.145)