Dimensions are shown in mm (inch)

Dimensions subject to change

120

RF Coaxial Connectors

Assembly Instructions

AI-472 & BAI-015

SMB & SMS Right Angle Connectors, Crimp Type for Braided Cable

1. Trim cable to dimensions shown taking care not to nick braid or center conductor. Tin center

conductor (DO NOT OVER TIN) then slip crimp ferrule (and tubing with SMS) over cable with

inspection hole toward trimmed end.

2. Insert trimmed cable into back end of body. The tubular body extension will slide under the braid

with the rear portion of extension fitting under the jacket as shown. The center conductor will

extend into slot in contact.

NOTE: On smaller diameter cables, two longitudinal slits in the jacket, 180

° apart, may be cut to

ease assembly.

3. Slip ferrule up over braid to face of square body and crimp, using ITT Cannon Crimp Tool and

suitable die set (see table).

4. Using a small soldering iron solder center conductor to contact.

NOTE: The center conductor should not protrude beyond the contact to touch the body. Solder

should not protrude beyond the slotted section of the contact.

5. Locate the cap in rear of body and dimple or lightly punch to ensure it is locked in position. (A flat

punch is recommended).

6. On SMS slip tubing over the ferrule and heat until the shrinkable tubing fits smoothly around the

cable.

Only common cable retention features are shown in detail. Various body configurations can apply.

CRIMP FERRULE

CAP

BODY

Assembly Instruction No.

A

B

C

BAI-015

10,00 (.393)

4,00 (.157)

1,50 (.059)

AI-472

11,10 (.437)

4,37 (.172)

0,79 (.031)

Cable Type

Cable Code

Die Size

RG142/U

9052

5,41 (.213)

RG196/U

3196

2,67 (.105)

RG316/U

0000

3,25 (.128)

RG316/U

3188/9416

3,25 (.128)

RD316

9399

3,84 (.151)