Dimensions are shown in mm (inch)

Dimensions subject to change

134

RF Coaxial Connectors

Assembly Instructions

BBAI-1203

Coaxial Terminations, 1 and 2 Point Direct PCB

Cable

Die Size

RG174/U

3,25 (.128)

RG178/U

2,67 (.105)

RG179/U

3,25 (.128)

RG188/U

3,25 (.128)

RG196/U

2,67 (.105)

RG316/U

3,25 (.128)

TAB FERRULE

CRIMP BODY

1. Trim cable to dimensions shown being careful not to nick or damage braids or center conductor.

Trim center conductor.

* These dimensions suit 2,54 (.100) and 7,62 (.300) PCB pitches, for other pitches see Note 4.

2. Slide Tab-Ferrule over cable.

NOTE: Orientation of tab-ferrule is optional depending upon mounting requirements. Flare braids

and slide crimp body over cable dielectric until braids meet flange on crimp body.

3. Slide tab-ferrule over braids to face of flange and crimp using ITT Cannon crimp tool and suitable

die set (see table).

4. Bend center conductor to dimension shown depending upon preferred orientation. These dimen-

sions suit 2,54 (.100) and 7,62 (.300) PCB pitches. For other pitches of 2,54 (.100) multiples add

2,54 (.100) multiples, to the 12,70 (.500) and 6,35 (.250) dimensions in the cable stripping

instructions Note 1.