AD9957SLASHPCBZ datasheet(55/60 Pages) AD

55 / 60 page

AD9957

Rev. 0 | Page 55 of 60

PROFILE REGISTERS

There are eight consecutive serial I/O addresses (0x0E to 0x15)

dedicated to device profiles. All eight profile registers are either

single tone profiles or QDUC profiles depending on the device

operating mode specified by CFR1 Bits<25:24>. During

operation, the active profile register is determined via the

external PROFILE<2:0> pins.

Single tone profiles control: DDS frequency (32 bits), DDS

phase offset (16 bits), and DDS amplitude scaling (14 bits).

QDUC profiles control: DDS frequency (32 bits), DDS phase

offset (16 bits), output amplitude scaling (8 bits), CCI filter

interpolation factor, inverse CCI bypass, and spectral invert.

The QDUC profiles also selectively apply to the interpolating

DAC operating mode: only output scaling, CCI filter

interpolation factor, and inverse CCI bypass apply; all others

(DDS frequency, output amplitude scaling, and spectral invert)

are ignored.

Profile<0:7> Register—Single

Tone

Address 0x0E to 0x15, eight bytes are assigned to this register.

Table 27. Bit Descriptions for Profile<0:7> Registers—Single Tone

Bits

Mnemonic

Description

63:62

Not Available

61:48

Amplitude Scale Factor

This 14-bit number controls the DDS output amplitude.

47:32

Phase Offset Word

This 16-bit number controls the DDS phase offset.

31:0

Frequency Tuning Word

This 32-bit number controls the DDS frequency.

Profile<0:7> Register—QDUC

Address 0x0E to 0x15, eight bytes are assigned to this register.

Table 28. Bit Descriptions for Profile<0:7> Registers—QDUC

Bits

Mnemonic

Description

63:58

CC Interpolation Rate

This 6-bit number is the rate interpolation factor for the CCI filter.

0: The modulator output takes the form: I(t) × cos( ct) – Q(t) × sin( ct).

Spectral Invert

1: The modulator output takes the form: I(t) × cos( ct) + Q(t) × sin( ct).

0: The inverse CCI filter is enabled.

Inverse CCI Bypass

1: The inverse CCI filter is bypassed.

55:48

Output Scale Factor

This 8-bit number controls the output amplitude.

47:32

Phase Offset Word

This 16-bit number controls the DDS phase offset.

31:0

Frequency Tuning Word

This 32-bit number controls the DDS frequency.

RAM Register

Address 0x16, four bytes are assigned to this register.

Table 29. Bit Descriptions for RAM Register

Bits

Mnemonic

Description

31:0

RAM Word

The number of 32-bit words written to RAM is defined by the start and end address in

AD9957/PCBZ 数据表(PDF) 55 Page - Analog Devices

AD9957/PCBZ 数据表(HTML) 55 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60

数据表下载

链接网址

AD9957/PCBZ 数据表(PDF) 55 Page - Analog Devices

AD9957/PCBZ 数据表(HTML) 55 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60

数据表 下载

链接网址

数据表下载