EV-RADAR-MMIC datasheet(4/28 Pages) AD

4 / 28 page

UG-866

EV-RADAR-MMIC2 User Guide

Rev. B | Page 4 of 28

QUICK START GUIDE

Follow these steps to evaluate the ADF5901, ADF5904, and

ADF4159 devices:

1. Connect the power supply to the EV-RADAR-MMIC2.

a. Supply 5 V to the VSUPPLY (P3) banana connector.

b. Connect GND to the GND (P2) banana connector.

2. Connect the power supplies to the EV-ADAR-D2S.

a. Supply 9 V to the VPOS SMA connector.

b. Supply −9 V to the VNEG SMA connector.

3. Connect the EV-ADAR-D2S board to the EV-RADAR-

MMIC2 evaluation board.

4. Install the EV-RADAR-MMIC software.

5. Connect the SDP motherboard to the PC and to the EV-

RADAR-MMIC2.

6. Follow the hardware driver installation procedure that

displays after the SDP motherboard connects to the PC.

7. Connect an antenna or a delay cable to the Tx (J9) and Rx (J6)

connectors (see Figure 8 and Figure 9).

8. Run the EV-RADAR-MMIC software.

9. Select the EV-RADAR-MMIC2 (the ADF5901, ADF5904,

and ADF4159 devices) and the SDP board in the Select

Device and Connection tab.

10. Check that SDP board connected appears on the status bar.

11. Click the ADF5904 Controls tab and then click Initialize.

12. Click the ADF4159 Controls tab and then click Write All

Registers.

13. Click the ADF5901 Controls tab and then click Initialize

ADF5901.

14. Click the Ramps and Shift Keying tab under the ADF4159

Controls tab to enable the ramp and then click Write R0.

15. Measure the output baseband signals on the EV-ADAR-

D2S board.

EV-RADAR-MMIC 数据表(PDF) 4 Page - Analog Devices

EV-RADAR-MMIC 数据表(HTML) 4 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28

数据表下载