PCF8563TSLASHF4 datasheet(17/45 Pages) NXP

17 / 45 page

PCF8563

All information provided in this document is subject to legal disclaimers.

Product data sheet

Rev. 11 — 26 October 2015

17 of 45

NXP Semiconductors

PCF8563

Real-time clock/calendar

8.9 EXT_CLK test mode

A test mode is available which allows for on-board testing. In such a mode it is possible to

set up test conditions and control the operation of the RTC.

The test mode is entered by setting bit TEST1 in register Control_status_1. Then

pin CLKOUT becomes an input. The test mode replaces the internal 64 Hz signal with the

signal applied to pin CLKOUT. Every 64 positive edges applied to pin CLKOUT will then

generate an increment of one second.

The signal applied to pin CLKOUT should have a minimum pulse width of 300 ns and a

maximum period of 1000 ns. The internal 64 Hz clock, now sourced from CLKOUT, is

divided down to 1 Hz by a 26 divide chain called a prescaler. The prescaler can be set into

a known state by using bit STOP. When bit STOP is set, the prescaler is reset to 0 (STOP

must be cleared before the prescaler can operate again).

From a STOP condition, the first 1 second increment will take place after 32 positive

edges on CLKOUT. Thereafter, every 64 positive edges will cause a one-second

increment.

Remark: Entry into EXT_CLK test mode is not synchronized to the internal 64 Hz clock.

When entering the test mode, no assumption as to the state of the prescaler can be made.

8.9.1 Operation example:

1. Set EXT_CLK test mode (Control_status_1, bit TEST1 = 1).

2. Set STOP (Control_status_1, bit STOP = 1).

3. Clear STOP (Control_status_1, bit STOP = 0).

4. Set time registers to desired value.

5. Apply 32 clock pulses to CLKOUT.

6. Read time registers to see the first change.

7. Apply 64 clock pulses to CLKOUT.

8. Read time registers to see the second change.

Repeat steps 7 and 8 for additional increments.

PCF8563T/F4 数据表(PDF) 17 Page - NXP Semiconductors

PCF8563T/F4 数据表(HTML) 17 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45

数据表下载