STDRIVE102H datasheet(20/56 Pages) STMICROELECTRONICS

20 / 56 page

The STDRIVE102BH/H implements two control modes: the enable/input mode (EN/IN) or the direct mode (INH/

INL), respectively explained in Section 5.2.1.1 and Section 5.2.1.2. The digital inputs assume a different function

according to the input mode selected:

•

In case the device is configured in Enable/Input mode:

–

INHx/INx → INx

–

INLx/ENx → ENx

•

In case the device is configured in Direct mode:

–

INHx/INx → INHx

–

INLx/ENx → INLx

In addition to the six digital inputs mentioned above, another digital input named EN (pin 47 for the

STDRIVE102BH and pin 1 for the STDRIVE102H) is used as general enable: in case it is forced to 0, all the six

gate drivers are set LOW, turning off all the external power MOSFETs. Setting EN to 1 activates the gate drivers,

which behave according to their related digital inputs. The EN pin also integrates an analog threshold Vrelease, to

release the latched condition after a FAULT event (refer to Section 5.6.1).

Figure 11. High-side driver simplified block diagram

VBOOT

GHSx

OUTx

Isource

Isink

Figure 12. Low-side driver simplified block diagram

VCC

GLSx

SLSx

Isource

Isink

STDRIVE102BH, STDRIVE102H

Device description

DS14545 - Rev 1

page 20/56

STDRIVE102H 数据表(PDF) 20 Page - STMicroelectronics

STDRIVE102H 数据表(HTML) 20 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56

数据表下载