STR910FAM32X6 datasheet(32/99 Pages) STMICROELECTRONICS

32 / 99 page

Functional overview

STR91xFAx32 STR91xFAx42 STR91xFAx44

32/99

and the Message SRAM, handling of transmission requests, and interrupt generation. The

CPU has access to the Message SRAM via the Message Handler using a set of 38 control

registers.

The follow features are supported by the CAN interface:

●

Bitrates up to 1 Mbps

●

Disable Automatic Retransmission mode for Time Triggered CAN applications

●

32 Message Objects

●

Each Message Object has its own Identifier Mask

●

Programmable FIFO mode

●

Programmable loopback mode for self-test operation

The CAN interface is not supported by DMA.

3.20

UART interfaces with DMA

The STR91xFA supports three independent UART serial interfaces, designated UART0,

UART1, and UART2. Each interface is very similar to the industry-standard 16C550 UART

device. All three UART channels support IrDA encoding/decoding, requiring only an external

LED transceiver to pins UARTx_RX and UARTx_Tx for communication. One UART channel

(UART0) supports full modem control signals.

UART interfaces include the following features:

●

Maximum baud rate of 1.5 Mbps

●

Separate FIFOs for transmit and receive, each 16 deep, each FIFO can be disabled by

firmware if desired

●

Programmable FIFO trigger levels between 1/8 and 7/8

●

Programmable baud rate generator based on CCU master clock, or CCU master clock

divided by two

●

Programmable serial data lengths of 5, 6, 7, or 8 bits with start bit and 1 or 2 stop bits

●

Programmable selection of even, odd, or no-parity bit generation and detection

●

False start-bit detection

●

Line break generation and detection

●

Support of IrDA SIR ENDEC functions for data rates of up to 115.2K bps

●

IrDA bit duration selection of 3/16 or low-power (1.14 to 2.23 µsec)

●

Channel UART0 supports modem control functions CTS, DCD, DSR, RTS, DTR, and

For your reference, only two standard 16550 UART features are not supported, 1.5 stop bits

and independent receive clock.

3.20.1

DMA

A programmable DMA channel may be assigned by CPU firmware to service channels

UART0 and UART1 for fast and direct transfers between the UART bus and SRAM with little

CPU involvement. Both DMA single-transfers and DMA burst-transfers are supported for

transmit and receive. Burst transfers require that UART FIFOs are enabled.

STR910FAM32X6 数据表(PDF) 32 Page - STMicroelectronics

STR910FAM32X6 数据表(HTML) 32 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99

数据表下载