| 数据搜索系统,热门电子元器件搜索 |
|
CBLUSB01 数据表(PDF) 24 Page - Red Lion Controls. Inc |
|
|
|||||||||||||||||||||||||||||
CBLUSB01 数据表(HTML) 24 Page - Red Lion Controls. Inc |
|
24 / 36 page ![]() 24 6-SPt ACt-n Setpoint Select SPSEL Setpoint Value SP-n Setpoint Source Src-n Output Logic out-n HYS-n Setpoint Hysteresis tON-n On Time Delay Off Time Delay tOF-n Standby Operation Stb-n Reset Action rSt-n PAR Pro Burn-out Action brn-n Setpoint Action LIt-n Setpoint Annunciators PAXT ONLY 6.6 mOdUle 6 - seTpOinT (alarm) parameTers () Ñ PARAMETER MENU Enter the setpoint (alarm output) to be programmed. The in the following parameters will reflect the chosen setpoint number. After the chosen setpoint is completely programmed, the display will return to . Repeat step for each setpoint to be programmed. The chosen at will return to . The number of setpoints available is setpoint output card dependent. SETPOINT SELECT Setpoint Alarm Figures With reverse output logic , the below alarm states are opposite. ALARM STATE OFF ON Hys SP + Hys SP OFF TRIGGER POINTS ALARM STATE ON OFF Hys SP1 + (-SPn) SP1 ON TRIGGER POINTS Absolute Low Acting (Unbalanced Hys) = Deviation High Acting (SP < 0) = ALARM STATE OFF ON Hys SP + ½Hys SP SP - ½Hys OFF TRIGGER POINTS ALARM STATE OFF ON Hys SP1 + SPn SP1 OFF TRIGGER POINTS ALARM STATE ON OFF Hys SP1 - (-SPn) SP1 ON TRIGGER POINTS Absolute Low Acting (Balanced Hys) = Deviation High Acting (SP > 0) = Deviation Low Acting (SP < 0)= ALARM STATE OFF ON Hys SP SP - Hys OFF TRIGGER POINTS ALARM STATE OFF ON Hys SP1 - SPn SP1 OFF TRIGGER POINTS ALARM STATE OFF ON Hys SP1 - SPn SP1 OFF SP1 + SPn ON OFF Hys TRIGGER POINTS Absolute High Acting (Unbalanced Hys) = This is also for Totalizer alarms: , Deviation Low Acting (SP > 0) = Band Outside Acting = ALARM STATE OFF ON Hys SP + ½Hys SP SP - ½Hys OFF TRIGGER POINTS Absolute High Acting (Balanced Hys) = Depending on the card installed, there will be two or four setpoint outputs available. For maximum input frequency, unused Setpoints should be configured for action. The setpoint assignment and the setpoint action determine certain setpoint feature availability. Ñ - A setpoint card must be installed in order to access this module. |
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |