ST10F271Z1 datasheet(161/185 Pages) STMICROELECTRONICS

161 / 185 page

ST10F271Z1

Electrical characteristics

161/185

Figure 52.

External clock drive XTAL1

Note:

When Direct Drive is selected, an external clock source can be used to drive XTAL1. The

maximum frequency of the external clock source depends on the duty cycle: when 64MHz is

used, 50% duty cycle shall be granted (low phase = high phase = 7.8 ns); when for instance

32 MHz is used, a 25% duty cycle can be accepted (minimum phase, high or low, again

equal to 7.8ns).

25.8.14

Memory cycle variables

The tables below use three variables which are derived from the BUSCONx registers and

represent the special characteristics of the programmed memory cycle. The following table

describes, how these variables are to be computed.

25.8.15

External memory bus timing

The following sections include the External Memory Bus timings. The given values are

computed for a maximum CPU clock of 40MHz.

Obviously, when higher CPU clock frequency is used (up to 64MHz), some numbers in the

timing formulas become zero or negative which, in most cases is not acceptable or not

meaningless at all. In these cases, it is necessary to relax the speed of the bus setting

properly tA, tC and tF.

Note:

All External Memory Bus Timings and SSC Timings reported in the following tables are

granted by Design Characterization and not fully tested in production.

25.8.16

Multiplexed bus

VDD = 5 V ± 10%, VSS = 0V, TA = –40 to +125 °C, CL = 50 pF,

ALE cycle time = 6 TCL + 2tA + tC + tF (75 ns at 40 MHz CPU clock without wait states)

VIL2

tOSC

VIH2

Table 77.

Memory cycle variables

Description

Symbol

Values

ALE extension

TCL x [ALECTL]

Memory cycle time wait states

2TCL x (15 - [MCTC])

Memory tri-state time

2TCL x (1 - [MTTC])

ST10F271Z1 数据表(PDF) 161 Page - STMicroelectronics

ST10F271Z1 数据表(HTML) 161 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载