| 数据搜索系统,热门电子元器件搜索 |
|
ST10R172LT6 数据表(PDF) 34 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
ST10R172LT6 数据表(HTML) 34 Page - STMicroelectronics |
|
34 / 68 page ![]() 34/68 ST10R172L - ELECTRICAL CHARACTERISTICS PORT0 configuration current3 IP0H 4 –-4 µAV IN = VIHmin IP0L 5 -50 – µAV IN = VILmax RPD pulldown current2 IRPD 5 100 500 µAV OUT = VDD XTAL1 input current IIL CC – ±20 µA 0 V < VIN < VDD Pin capacitance6) (digital inputs/outputs) CIO CC – 10 pF f = 1 MHz TA = 25 °C Power supply current ICC –15 + 2.5 * fCPU mA fCPU in [MHz] 7)) Idle mode supply current IID –10 + 0.9 * fCPU mA RSTIN = VIH1 fCPU in [MHz] 7 Power-down mode supply current I PD 8 –200 µA VDD = 3.6 V 9 1) This specification is not valid for outputs which are switched to open drain mode. In this case the respective output will float and the resulting voltage comes from the external circuitry. 2) This specification is only valid during reset, or interruptible power-down mode, after recep- tion of an external interrupt signal that will wake up the CPU. 3) This specification is only valid during reset, hold or adapt-mode. Port 6 pins are only affected if they are used for CS output and the open drain function is not enabled. 4) The maximum current may be drawn while the signal line remains inactive. 5) The minimum current must be drawn in order to drive the signal line active. 6) Not 100% tested, guaranteed by design characterization. 7) Supply current is a function of operating frequency as illustrated in Figure 7 on page 35. This parameter is tested at VDDmax and 50 MHz CPU clock with all outputs disconnected and all inputs at VIL or VIH with an infinite execution of NOP instruction fetched from external memory (16-bit demux bus mode, no waitstates, no memory tri-state waitstates, normal ALE). 8) Typical value at 25°C = 20µA. 9) This parameter is tested including leakage currents. All inputs (including pins configured as inputs) at 0 V to 0.1 V or at VDD – 0.1 V to VDD, VREF = 0 V, all outputs (including pins con- figured as outputs) disconnected. Parameter Symbol Limit Values Unit Test Condition min. max. Table 11 DC characteristics 1 |
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |