ST10R172LT6 datasheet(38/68 Pages) STMICROELECTRONICS

38 / 68 page

38/68

ST10R172L - ELECTRICAL CHARACTERISTICS

15.3.1 Cpu Clock Generation Mechanisms

ST10R172L internal operation is controlled by the CPU clock fCPU. Both edges of the CPU

clock can trigger internal (e.g. pipeline) or external (e.g. bus cycles) operations. The external

timing (AC Characteristics) specification therefore depends on the time between two consec-

utive edges of the CPU clock, called “TCL” (see figure below).

The CPU clock signal can be generated by different mechanisms. The duration of TCLs and

their variation (and also the external timing) depends on the fCPU generation mechanism. This

must be considered when calculating ST10R172L timing.

The CPU clock generation mechanism is set during reset by the logic levels on pins P0.15-13

(P0H.7-5).

Figure 11 CPU clock generation mechanisms

P0.15-13 (P0H.7-5)

CPU frequency

fCPU = fXTAL * F

External clock

input range 10-

50MHz

Notes

111

XTAL * 4

2.5 to 12.5 MHz

Default configuration

110

XTAL * 3

3.33 to 16.66 MHz

101

XTAL * 2

5 to 25 MHz

Table 12 CPU clock generation mechanisms

TCL TCL

fCPU

fXTAL

fCPU

fXTAL

Phase Locked Loop Operation (PLL factor=4)

Direct Clock Drive

TCL

fCPU

fXTAL

Prescaler Operation

ST10R172LT6 数据表(PDF) 38 Page - STMicroelectronics

ST10R172LT6 数据表(HTML) 38 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68

数据表下载

链接网址

ST10R172LT6 数据表(PDF) 38 Page - STMicroelectronics

ST10R172LT6 数据表(HTML) 38 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68

数据表 下载

链接网址

数据表下载