STV2310 datasheet(22/112 Pages) STMICROELECTRONICS

22 / 112 page

Functional Description

STV2310

22/112

should be identified. If two entries are identified by error, the standard recognition sequence will re-

start from the beginning of the table and no standard will be identified.

The DDECCONT4[5:0], DDECCONT3[5:0], DDECCONT2[5:0], and DDECCONT1[5:0] registers

are used to program the Automatic Standard Recognition table.

After the sequence search, a second step (also called a confirmation step) is performed by the

algorithm. It is performed on the single identified Automatic Standard Recognition table entry. It is

possible to program the number of fields where the standard identification must be confirmed before

the status flags are modified. The confirmation code is described in Table 8.

The confirmation code is programmed in the STI_NB_FIELDS_CONFIRM[2:0] bits of the

DDECCONT17 register.

After the confirmation step has been successful, the standard is considered as identified. The

TVSTID flag is set in the DDECSTAT2 register and the code of the identified standard is set in the

TVSTD[2:0] bits of the DDECSTAT2 register.

4.6

Standard Identification

The input signal standard is automatically recognized using a proprietary ST patented algorithm. It

avoids false identification and ensures a good recognition of the color standard, even in bad signal

conditions.

4.7

Chroma Demodulation

4.7.1

General Description

The Chroma PLL and the Input SRC are the main hardware blocks involved in chroma

demodulation. The Chroma PLL is locked to the input video burst signal in frequency and phase.

Demodulation is performed on the chroma samples positioned in the virtual 4 x fSC clock domain.

Dedicated demodulation hardware is used for SECAM demodulation (frequency modulated

signals). Demodulated chroma components are low pass filtered and matrixed into Cr and Cb

components.

The Chroma Demodulator also includes an Automatic Chroma Control (ACC) which rescales the

chroma components from -20 dB to +6 dB. The color is killed (output Cr Cb components to 80h

value) until the standard is identified. ACC is disabled (fixed gain) in SECAM standard.

If NTSC M or NTSC 4.43 standards are identified, the Chroma Demodulator also incorporates a

Hue Control mechanism and a Flesh Tone Correction mechanism. The Hue Control is a

programmable fixed offset in the demodulation angle and is only operational in the active line.

Table 8: Confirmation Codes

Confirmation

Code

Number of Successive Fields

with Correct Identification

000

001

3 (Default)

010

011

STV2310 数据表(PDF) 22 Page - STMicroelectronics

STV2310 数据表(HTML) 22 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载