CS2000-OTP

DS758PP1

13

remain continuous throughout the missing CLK_IN period including the time while the PLL re-acquires

lock.

5.3.2

Adjusting the Minimum Loop Bandwidth for CLK_IN

The CS2000 allows the minimum loop bandwidth of the Digital PLL to be adjusted between 1 Hz and

128 Hz using the ClkIn_BW[2:0] global parameter. The minimum loop bandwidth of the Digital PLL direct-

ly affects the jitter transfer function; specifically, jitter frequencies below the loop bandwidth corner are

passed from the PLL input directly to the PLL output without attenuation. In some applications it is desir-

able to have a very low minimum loop bandwidth to reject very low jitter frequencies, commonly referred

to as wander. In others it may be preferable to remove only higher frequency jitter, allowing the input wan-

der to pass through the PLL without attenuation.

Typically, applications in which the PLL_OUT signal creates a new clock domain from which all other sys-

tem clocks and associated data are derived will benefit from the maximum jitter and wander rejection of

the lowest PLL bandwidth setting. See Figure 10.

Systems in which some clocks and data are derived from the PLL_OUT signal while other clocks and data

are derived from the CLK_IN signal will often require phase alignment of all the clocks and data in the

system. See Figure 11. If there is substantial wander on the CLK_IN signal in these applications, it may

be necessary to increase the minimum loop bandwidth allowing this wander to pass through to the

Referenced Control

Parameter Definition

ClkSkipEn..............................“Clock Skip Enable (ClkSkipEn)” on page 25

ClkOutUnl..............................“Enable PLL Clock Output on Unlock (ClkOutUnl)” on page 25

CLK_IN

PLL_OUT

UNLOCK

ClkSkipEn=1

ClkOutUnl=0 or 1

CLK_IN

PLL_OUT

UNLOCK

ClkSkipEn=0

ClkOutUnl=1

Lock Time

CLK_IN

PLL_OUT

UNLOCK

ClkSkipEn=0

ClkOutUnl=0

Lock Time

= invalid clocks

Figure 10. Low bandwidth and new clock domain

LRCK

SCLK

SDATA

MCLK

MCLK

Wander > 1 Hz

Wander and Jitter > 1 Hz Rejected

D0

D1

LRCK

SCLK

SDATA

Subclocks generated

from new clock domain.

or

PLL

BW = 1 Hz

CLK_IN

PLL_OUT

D0

D1

Jitter