PCF2129AT datasheet(41/68 Pages) NXP

41 / 68 page

PCF2129A_1

Product data sheet

Rev. 01 — 13 January 2010

41 of 68

NXP Semiconductors

PCF2129A

Integrated RTC, TCXO and quartz crystal

8.13 External clock test mode

A test mode is available which allows on-board testing. In this mode it is possible to set up

test conditions and control the operation of the RTC.

The test mode is entered by setting bit EXT_TEST logic 1 (register Control_1). Then

pin CLKOUT becomes an input. The test mode replaces the internal clock signal (64 Hz)

with the signal applied to pin CLKOUT. Every 64 positive edges applied to pin CLKOUT

generate an increment of one second.

The signal applied to pin CLKOUT should have a minimum pulse width of 300 ns and a

maximum period of 1000 ns. The internal clock, now sourced from CLKOUT, is divided

down by a 26 divider chain called prescaler (see prescaler in Table 46). The prescaler can

be set into a known state by using bit STOP. When bit STOP is logic 1, the prescaler is

reset to 0. STOP must be cleared before the prescaler can operate again.

From a stop condition, the first 1 second increment will take place after 32 positive edges

on pin CLKOUT. Thereafter, every 64 positive edges will cause a 1 second increment.

Remark: Entry into test mode is not synchronized to the internal 64 Hz clock. When

entering the test mode, no assumption as to the state of the prescaler can be made.

Operating example:

1. Set EXT_TEST test mode (register Control_1, EXT_TEST is logic 1).

2. Set bit STOP (register Control_1, STOP is logic 1).

3. Set time registers to desired value.

4. Clear STOP (register Control_1, STOP is logic 0).

5. Apply 32 clock pulses to CLKOUT.

6. Read time registers to see the first change.

7. Apply 64 clock pulses to CLKOUT.

8. Read time registers to see the second change.

Repeat 7 and 8 for additional increments.

PCF2129AT 数据表(PDF) 41 Page - NXP Semiconductors