LIS331DLF

Digital interfaces

Doc ID 15101 Rev 4

19/38

Data are transmitted in byte format (DATA). Each data transfer contains 8 bits. The number

of bytes transferred per transfer is unlimited. Data is transferred with the Most Significant bit

(MSb) first. If a receiver can’t receive another complete byte of data until it has performed

some other function, it can hold the clock line, SCL LOW to force the transmitter into a wait

state. Data transfer only continues when the receiver is ready for another byte and releases

the data line. If a slave receiver doesn’t acknowledge the slave address (i.e. it is not able to

receive because it is performing some real time function) the data line must be left HIGH by

the slave. The Master can then abort the transfer. A LOW to HIGH transition on the SDA line

while the SCL line is HIGH is defined as a STOP condition. Each data transfer must be

terminated by the generation of a STOP (SP) condition.

In order to read multiple bytes, it is necessary to assert the most significant bit of the sub-

address field. In other words, SUB(7) must be equal to 1 while SUB(6-0) represents the

address of first register to be read.

In the presented communication format MAK is master acknowledge and NMAK is no

master acknowledge.

5.2

SPI bus interface

The LIS331DLF SPI is a bus slave. The SPI allows to write and read the registers of the

device.

The Serial Interface interacts with the outside world with 4 wires: CS, SPC, SDI and SDO.

Table 12.

Transfer when master is writing multiple bytes to slave:

Master

ST

SAD + W

SUB

DATA

DATA

SP

Slave

SAK

SAK

SAK

SAK

Table 13.

Transfer when master is receiving (reading) one byte of data from slave:

Master

ST

SAD + W

SUB

SR

SAD + R

NMAK

SP

Slave

SAK

SAK

SAK

DATA

Table 14.

Transfer when Master is receiving (reading) multiple bytes of data from slave

Master

ST SAD+W

SUB

SR SAD+R

MAK

MAK

NMAK

SP

Slave

SAK

SAK

SAK

DATA

DATA

DATA