R5F364AMNFB datasheet(90/92 Pages) RENESAS

90 / 92 page

A - 2

2.00

Feb 07, 2011

Address Space

Figure 3.2 Memory Map:

• Added the address of 384 KB version.

• Added note 1 and 3 to the reserved areas.

Special Function Registers (SFRs)

Table 4.1 SFR Information (1) (1):

• Deleted “the VCR1 register, the VCR2 register” from note 2.

• Deleted notes 5 to 6 and added note 5.

Table 4.2 SFR Information (2) (1): Deleted notes 2 to 7 and added note 2.

4.2.1 Register Settings: Added the description regarding read-modify-write instructions.

Table 4.20 Read-Modify-Write Instructions: Added.

Electrical Characteristics

Table 5.1 Absolute Maximum Ratings:

Added a row for the data area value to Topr (Flash program erase).

Table 5.2 Recommended Operating Conditions (1/3):

Added rows for the CEC value to VCC1, VCC2, VIH, and VIL.

Table 5.9 Flash Memory (Program ROM 1, 2) Electrical Characteristics:

Added a condition to the Read voltage row.

Table 5.14 Power-On Reset Circuit:

• Added the tw(por) row.

• Added the last line in note 1.

Figure 5.3 Power-On Reset Circuit Electrical Characteristics: Deleted note 2.

Table 5.18 Electrical Characteristics (2) (1): Added “ZP, IDU, IDV, IDW” to the VT+-VT- row.

Table 5.20 Electrical Characteristics (4): Added new part numbers above the table.

60, 78

Table 5.33 and Table 5.53 Multi-master I2C-bus: Added.

Table 5.34 Memory Expansion Mode and Microprocessor Mode:

Changed

RDY input setup time from 30.

61 to 68,

79 to 86

Table 5.34 to Table 5.37 and Table 5.54 to Table 5.57 Memory Expansion Mode and

Microprocessor Mode:

Deleted the following:

•

HOLD input setup time

•

HOLD input hold time

•

HLDA output delay time

62, 80

Figure 5.13 and Figure 5.26 Timing Diagram:

Deleted lower figure (Common to wait state and no wait state settings).

Table 5.38 Electrical Characteristics (1) (1):

• Added rows for the CEC value to Leakage current in powered-off state, VT+-VT-, and

VOL.

• Added “ZP, IDU, IDV, IDW” to the VT+-VT- row.

Table 5.39 Electrical Characteristics (2): Changed “VCC1 = 5.0 V” to "VCC1 = 3.0 V" in the

During flash memory program and During flash memory erase rows.

Table 5.40 Electrical Characteristics (3):

• Added new part numbers above the table.

• Changed “VCC1 = 5.0 V” to "VCC1 = 3.0 V" in the During flash memory program and

During flash memory erase rows.

Table 5.54 Memory Expansion Mode and Microprocessor Mode:

Changed

RDY input setup time from 40.

REVISION HISTORY

M16C/64A Group Datasheet

Rev.

Date

Description

Page

Summary

All trademarks and registered trademarks are the property of their respective owners.

IEBus is a registered trademark of NEC Electronics Corporation.

HDMI and High-Definition Multimedia Interface are registered trademarks of HDMI Licensing, LLC.

R5F364AMNFB 数据表(PDF) 90 Page - Renesas Technology Corp

R5F364AMNFB 数据表(HTML) 90 Page - Renesas Technology Corp

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92

数据表下载