TNETA1500

155.52-MBIT/S SONET/SDH ATM RECEIVER/TRANSMITTER

SDNS021D – MARCH 1994 – REVISED JANUARY 1998

1

POST OFFICE BOX 655303

Transporting 53-Byte ATM Cells Via

STS-3c/STM-1 Frame (155.52 Mbit/s)

(APLL) Provides:

– Recovery of Receive Clock From

Incoming Serial-Data Stream

– Transmit Clock Generation From

External 19.44-MHz Clock Source

SONET/SDH STS-3c/STM-1 SPE

Single-Bit Errors in the 5-Byte ATM

Headers of Incoming ATM Cells

– Loss of Incoming Serial Signal (LOS)

– Out of Frame (OOF)

– Loss of Frame (LOF)

– B1-Byte Parity Error (B1ERR)

– Loss of ATM Cell Alignment (LOCA)

– Line Far-End Receive Failure (LFERF)

– Receive Loss of Pointer (LOP)

– Line Alarm Indication Signal (LAIS)

Interface Specification Requirement

Plastic Quad Flat Package (PQFP) or a

144-Pin Thin Quad Flat Package (TQFP)

description

The synchronous optical network (SONET)/synchronous digital hierarchy (SDH) asynchronous transport mode

(ATM) line-interface receiver/transmitter provides a single-chip implementation for transporting ATM cells over

the SONET/SDH network at the STS-3c/STM-1 rate of 155.52 Mbit/s. This device provides all the functionality

required to insert and extract 53-byte ATM cells into/from an STS-3c/STM-1 synchronous payload envelope

(SPE), including clock recovery and clock generation using analog phase-locked loops (APLL).

On the receive side, the TNETA1500 accepts 155.52-Mbit/s serial data, recovers the embedded clock signal,

performs SONET/SDH frame alignment and serial-to-parallel conversion, identifies the SONET/SDH payload,

and establishes the ATM-cell boundaries. The ATM cells are extracted from the payload, descrambled, and

passed to the receive output FIFO for output to the next device (i.e., a reassembly device). On the transmit side,

complete 53-byte ATM cells are placed into the transmit input FIFO, scrambled, and inserted into an

STS-3c/STM-1 SPE. The SONET/SDH frame is scrambled and converted to a serial-data stream for output.

An APLL is used to generate the 155.52-MHz output clock from a low-speed 19.44-MHz oscillator, eliminating

the need for a high-speed 155.52-MHz oscillator.

Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of

Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.

PRODUCTION DATA information is current as of publication date.

Products conform to specifications per the terms of Texas Instruments

standard warranty. Production processing does not necessarily include

testing of all parameters.

Copyright

© 1998, Texas Instruments Incorporated