AM29F100 datasheet(12/36 Pages) AMD

12 / 36 page

Am29F100

Autoselect Command Sequence

The autoselect command sequence allows the host

system to access the manufacturer and devices codes,

and determine whether or not a sector is protected.

The Command Definitions table shows the address

and data requirements. This method is an alternative to

that shown in the Autoselect Codes (High Voltage

Method) table, which is intended for PROM program-

mers and requires VID on address bit A9.

The autoselect command sequence is initiated by

writing two unlock cycles, followed by the autoselect

command. The device then enters the autoselect

mode, and the system may read at any address any

number of times, without initiating another command

sequence.

A read cycle at address XX00h or retrieves the manu-

facturer code. A read cycle at address XX01h in word

mode (or 02h in byte mode) returns the device code.

A read cycle containing a sector address (SA) and the

address 02h in word mode (or 04h in byte mode) re-

turns 01h if that sector is protected, or 00h if it is un-

protected. Refer to the Sector Address tables for valid

sector addresses.

The system must write the reset command to exit the

autoselect mode and return to reading array data.

Word/Byte Program Command Sequence

The system may program the device by byte or word,

on depending on the state of the BYTE# pin. Program-

ming is a four-bus-cycle operation. The program com-

mand sequence is initiated by writing two unlock write

cycles, followed by the program set-up command. The

program address and data are written next, which in

turn initiate the Embedded Program algorithm. The

system is

not required to provide further controls or tim-

ings. The device automatically provides internally gen-

erated program pulses and verify the programmed cell

margin. The Command Definitions take shows the ad-

dress and data requirements for the byte program com-

mand sequence.

When the Embedded Program algorithm is complete,

the device then returns to reading array data and ad-

dresses are no longer latched. The system can deter-

mine the status of the program operation by using

DQ7, DQ6, or RY/BY#. See “Write Operation Status”

for information on these status bits.

Any commands written to the device during the Em-

bedded Program Algorithm are ignored. Note that a

hardware reset immediately terminates the program-

ming operation. The program command sequence

should be reinitiated once the device has reset to read-

ing array data, to ensure data integrity.

Programming is allowed in any sequence and across

sector boundaries. A bit cannot be programmed

from a “0” back to a “1”. Attempting to do so may halt

the operation and set DQ5 to “1”, or cause the Data#

Polling algorithm to indicate the operation was suc-

cessful. However, a succeeding read will show that the

data is still “0”. Only erase operations can convert a “0”

to a “1”.

Note: See the appropriate Command Definitions table for

program command sequence.

Figure 2.

Program Operation

START

Write Program

Command Sequence

Data Poll

from System

Verify Data?

Yes

Last Address?

Yes

Programming

Completed

Increment Address

Embedded

Program

algorithm

in progress

18926C-7

AM29F100 数据表(PDF) 12 Page - Advanced Micro Devices

AM29F100 数据表(HTML) 12 Page - Advanced Micro Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36

数据表下载