| 数据搜索系统,热门电子元器件搜索 |
|
AN4471 数据表(PDF) 7 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
AN4471 数据表(HTML) 7 Page - STMicroelectronics |
|
7 / 39 page ![]() DocID026197 Rev 1 7/39 AN4471 Hardware layout and configuration 39 • VDDM: Negative supply voltage -3.3 V to 0 (J2 conn.) • GND: Ground (J2 conn.) • HVMCW: Continuous wave high voltage negative supply (J3 conn.) • HVM0: TX high voltage negative supply (J3 conn.) • GND: Ground (J3 conn.) 3.2 MCU The STM32F103C8T6 updates the waveform and the FPGA bit stream on the SPI Flash memory. It is already pre-programmed as a DFU (device firmware upgrade) device and can upgrade internal and external Flash memory. The STM32F103 manages all the DFU operations, such as the authentication of product identifier, vendor identifier, Firmware version as well as the alternate setting number (Target ID). This is used to upgrade the SPI Flash memory hosted on the STEVAL-IME009V1 and render the upgrade more secure. Note: See AN3156, UM0412 and UM1083 for further details about the upgrade through DFU. 3.3 SPI Flash memory The STEVAL-IME009V1 hosts a Micron N25Q032 (U9), it is a 32-Mbit (4 Mb x 8) serial Flash memory with advanced write protection mechanisms. It can be accessed by a high speed SPI-compatible bus and can even work in XIP (eXecution in Place) mode. The N25Q032 also supports the high-performance quad I/O instructions used by the FPGA to quadruple the transfer bandwidth for read and program operations. If extra data memory is needed, the user can connect external Flash memory to the J10 connector. When the external Flash is plugged, LED D29 is on Table 3. The Flash memory is configured by setting J38 as described in Table 4. Table 3. SPI Flash memory LED Color Name Description D29 Green EXT SPI-FLASH The external SPI-Flash module is connected D30 Red On-board SPI-FLASH The on-board SPI-Flash is used Table 4. SPI Flash memory jumper Status Description J38 Closed Fitted (default setting): enable the power supply to the on-board SPI Flash memory (U9). Open Unfitted: disable the power supply to the on-board SPI Flash memory. |
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |