AN4471 datasheet(4/39 Pages) STMICROELECTRONICS

部件名	AN4471

功能描述	STEVAL-IME009V1 evaluation board based on the STHV800 high voltage pulser

PDF	39 Pages

Scroll/Zoom	100%

制造商	STMICROELECTRONICS [STMicroelectronics]

网页	http://www.st.com

标志

4 / 39 page

Getting started

AN4471

4/39

DocID026197 Rev 1

Getting started

The STEVAL-IME009V1 is shipped by STMicroelectronics and is ready to use in Normal

mode. The user only needs to:

Connect the right power supply to the board (see Section 3.1)

Connect the BNC to the oscilloscope

Check that switch SW1 is set on the FPGA position (see Table 1 in Section 3.1)

Check that the LED labeled “DONE” (D23) is on

Check that FPGA is in the idle state (LED D4 is on)

Select the waveform with the Program button; the corresponding program LED (D6-

D21) turns on

Press the START button to run the selected program; the START LED (D2) turns on

The selected waveform is output until the STOP button is pressed and the relative LED

(D3) turns on. After the program ends, the FPGA returns to the idle state (LED D4 is

on)

To run the same program again, restart from step 7; to run another program, restart

from step 6

For Programming mode, please refer to UM1083.

AN4471 数据表(PDF) 4 Page - STMicroelectronics