LTC1098AC datasheet(18/28 Pages) LINER

18 / 28 page

LTC1096/LTC1096L

LTC1098/LTC1098L

Figure 7. LTC1098(L) “+” and “–” Input Settling Windows

CLK

DIN

DOUT

"+" INPUT

"–" INPUT

SAMPLE

HOLD

"+" INPUT MUST

SETTLE DURING

THIS TIME

tSMPL

tCONV

SGL/DIFF

START

MSBF

DON'T CARE

1ST BIT TEST "–" INPUT MUST

SETTLE DURING THIS TIME

LTC1096/8 • F07

APPLICATI

I FOR ATIO

(Figure 6) and connect the center point to the MPU input.

It should be noted that to get full shutdown, the CS input

of the LTC1096/LTC1098 must be driven to the VCC

voltage. This would require adding a level shift circuit to

the CS signal in Figure 6.

+IN

–IN

GND

VCC

CLK

DOUT

VREF

50k

4.7

µF

MPU

(e.g. 8051)

P1.4

P1.3

P1.2

LTC1096/98 • F06

DIFFERENTIAL INPUTS

COMMON MODE RANGE

0V TO 6V

LTC1096

OPTIONAL

LEVEL SHIFT

Figure 6. Interfacing a 9V Powered LTC1096 to a 5V System

BOARD LAYOUT CONSIDERATIONS

Grounding and Bypassing

The LTC1096(L)/LTC1098(L) should be used with an ana-

log ground plane and single point grounding techniques.

The GND pin should be tied directly to the ground plane.

The VCC pin should be bypassed to the ground plane with

a 1

µF tantalum with leads as short as possible. If power

supply is clean, the LTC1096(L)/LTC1098(L) can also

operate with smaller 0.1

µF surface mount or ceramic

bypass capacitors. All analog inputs should be referenced

directly to the single point ground. Digital inputs and

outputs should be shielded from and/or routed away from

the reference and analog circuitry.

SAMPLE-AND-HOLD

Both the LTC1096(L) and the LTC1098(L) provide a built-

in sample-and-hold (S&H) function to acquire signals.

The S&H of the LTC1096(L) acquires input signals from

“+” input relative to “–” input during the tWAKEUP time (see

Figure 1). However, the S&H of the LTC1098(L) can

sample input signals in the single-ended mode or in the

differential inputs during the tSMPL time (see Figure 7).

Single-Ended Inputs

The sample-and-hold of the LTC1098(L) allows conver-

sion of rapidly varying signals. The input voltage is sampled

during the tSMPL time as shown in Figure 7. The sampling

interval begins as the bit preceding the MSBF bit is shifted

LTC1098AC 数据表(PDF) 18 Page - Linear Technology

LTC1098AC 数据表(HTML) 18 Page - Linear Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28

数据表下载