STM32F479AI datasheet(66/208 Pages) STMICROELECTRONICS

66 / 208 page

Pinouts and pin description

STM32F479xx

66/208

DocID028010 Rev 2

168 199

PB9

I/O

TIM4_CH4, TIM11_CH1,

I2C1_SDA,

SPI2_NSS/I2S2_WS,

CAN1_TX, SDIO_D5,

DCMI_D7, LCD_B7,

EVENTOUT

A10

169 200

PE0

I/O

TIM4_ETR, UART8_Rx,

FMC_NBL0, DCMI_D2,

EVENTOUT

170 201

PE1

I/O

UART8_Tx, FMC_NBL1,

DCMI_D3, EVENTOUT

B10

202

VSS

171 203

PDR_ON

A11

172 204

VDD

D10

173 205

PI4

I/O

TIM8_BKIN, FMC_NBL2,

DCMI_D5, LCD_B4,

EVENTOUT

C10

174 206

PI5

I/O

TIM8_CH1, FMC_NBL3,

DCMI_VSYNC, LCD_B5,

EVENTOUT

B11

175 207

PI6

I/O

TIM8_CH2, FMC_D28,

DCMI_D6, LCD_B6,

EVENTOUT

A12

176 208

PI7

I/O

TIM8_CH3, FMC_D29,

DCMI_D7, LCD_B7,

EVENTOUT

1. Function availability depends on the chosen device.

2. PC13, PC14, PC15 and PI8 are supplied through the power switch. Since the switch only sinks a limited amount of current (3

mA), the use of GPIOs PC13 to PC15 and PI8 in output mode is limited:

- The speed should not exceed 2 MHz with a maximum load of 30 pF.

- These I/Os must not be used as a current source (e.g. to drive an LED).

3. Main function after the first backup domain power-up. Later on, it depends on the contents of the RTC registers even after

reset (because these registers are not reset by the main reset). For details on how to manage these I/Os, refer to the RTC

www.st.com.

FT = 5 V tolerant except when in analog mode or oscillator mode (for PC14, PC15, PH0 and PH1).

5. If the device is delivered in an WLCSP168, UFBGA169, UFBGA176, LQFP176 or TFBGA216 package, and the

BYPASS_REG pin is set to VDD (Regulator OFF/internal reset ON mode), then PA0 is used as an internal Reset (active low).

6. PI0 and PI1 cannot be used for I2S2 full-duplex mode.

7. NC (not-connected) pins are not bonded. They must be configured by software to output push-pull and forced to 0 in the

output data register to avoid extra current consumption in low power modes.

Table 10. STM32F479xx pin and ball definitions (continued)

Pin Number

Pin name

(function after

reset)(1)

Alternate functions

Additional

functions

STM32F479AI 数据表(PDF) 66 Page - STMicroelectronics

STM32F479AI 数据表(HTML) 66 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载

链接网址

STM32F479AI 数据表(PDF) 66 Page - STMicroelectronics

STM32F479AI 数据表(HTML) 66 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表 下载

链接网址

数据表下载