Parameter

Symbol

Min

Typ

Max

Units

DC Power Supplies: Positive Digital

(VA+)-(VA-)

Positive Analog

Negative Analog

VD+

VA+

VA-

3.15

4.5

4.5

0

5.0

10

5.0

-5.0

5.5

11

11

-5.5

V

V

V

V

Analog Reference Voltage (Note 20) (VREF+)-(VREF-)

1.0

2.5

3.6

V

Analog Input Voltage:

(Note 21)

Unipolar

Bipolar

VAIN

VAIN

0

-((VREF+)-(VREF-))

-

-

(VREF+)-(VREF-)

+((VREF+)-(VREF-))

V

V

Notes: 19. All voltages with respect to ground.

20. The CS5505/6/7/8 can be operated with a reference voltage as low as 100 mV; but with a

corresponding reduction in noise-free resolution. The common mode voltage of the voltage reference

may be any value as long as +VREF and -VREF remain inside the supply values of VA+ and VA-.

21. The CS5505/6/7/8 can accept input voltages up to the analog supplies (VA+ and VA-). In unipolar

mode the CS5505/6/7/8 will output all 1’s if the dc input magnitude ((AIN+)-(AIN-)) exceeds

((VREF+)-(VREF-)) and will output all 0’s if the input becomes more negative than 0 Volts.

In bipolar mode the CS5505/6/7/8 will output all 1’s if the dc input magnitude ((AIN+)-(AIN-)) exceeds

((VREF+)-(VREF-)) and will output all 0’s if the input becomes more negative in magnitude than

-((VREF+)-(VREF-)).

ABSOLUTE MAXIMUM RATINGS*

Parameter

Symbol

Min

Typ

Max

Units

DC Power Supplies:

Digital Ground

(Note 22)

Positive Digital

(Note 23)

Positive Analog

Negative Analog

(VA+)-(VA-)

(VA+)-(VD+)

DGND

VD+

VA+

VA-

-0.3

-0.3

-0.3

+0.3

-0.3

-0.3

-

-

-

-

-

-

(VD+)-0.3

6.0 or VA+

12.0

-6.0

12.0

12.0

V

V

V

V

V

V

Input Current, Any Pin Except Supplies

(Notes 24, 25)

--

±10

mA

Analog Input Voltage

AIN and VREF pins

(VA-)-0.3

-

(VA+)+0.3

V

Digital Input Voltage

-0.3

-

(VD+)+0.3

V

Ambient Operating Temperature

-55

-

125

°C

Storage Temperature

-65

-

150

°C

Notes: 22. No pin should go more positive than (VA+)+0.3V.

23. VD+ must always be less than (VA+)+0.3 V,and can never exceed 6.0V.

24. Applies to all pins including continuous overvoltage conditions at the analog input (AIN) pin.

25. Transient currents of up to 100mA will not cause SCR latch-up. Maximum input current for a power

supply pin is

± 50 mA.

* WARNING: Operation at or beyond these limits may result in permanent damage to the device.

Normal operation is not guaranteed at these extremes.

CS5505/6/7/8

12

DS59F4

CS5505/6/7/8

12

DS59F5