EiceDRIVER™

6ED003L06-F2, 6ED003L02-F2

datasheet

5

<Revision 2.8>, 05.08.2016

EiceDRIVER™

3 phase 600 V gate drive IC

1

Overview

Main features



Thin-film-SOI-technology



Maximum blocking voltage +600V



Separate control circuits for all six drivers



CMOS and LSTTL compatible input (negative logic)



Signal interlocking of every phase to prevent cross-conduction



Detection of over current and under voltage supply



externally programmable delay for fault clear after over current

detection

Product highlights



Insensitivity of the bridge output to negative transient voltages up to -50V given by SOI-technology



'shut down' of all switches during error conditions

Typical applications



Home appliances



Fans, pumps



General purpose drives

Product family

Table 1

Members of 6ED family

– 2

Sales Name

high side control input

HIN1,2,3 and LIN1,2,3

typ. UVLO-

Thresholds

Bootstrap

diode

Package

6ED003L06-F2 / 6ED003L02-F2

negative logic

11.7 V / 9.8 V

No

DSO28 / TSSOP28

Description

The devices are full bridge drivers to control power devices like MOS-transistors or IGBTs in 3-phase systems

with a maximum blocking voltage of +600 V. Based on the used SOI-technology there is an excellent

ruggedness on transient voltages. No parasitic thyristor structures are present in the device. Hence, no parasitic

latch-up may occur at all temperatures and voltage conditions.

The six independent drivers are controlled at the low-side using CMOS resp. LSTTL compatible signals, down

to 3.3 V logic. The device includes an under-voltage detection unit with hysteresis characteristic and an over-

current detection. The over-current level is adjusted by choosing the resistor value and the threshold level at pin

ITRIP. Both error conditions (under-voltage and over-current) lead to a definite shut down of all six switches. An

error signal is provided at the FAULT open drain output pin. The blocking time after over-current can be

adjusted with an RC-network at pin RCIN. The input RCIN owns an internal current source of 2.8 µA. Therefore,

down. Because of system safety reasons a 310 ns interlocking time has been realised. The function of input EN

can optionally be extended with an over-temperature detection, using an external NTC-resistor (see Fig.1).

PG-DSO28

PG-TSSOP28