TLE7183F

General Product Characteristics

Data Sheet

10

2.2, 2016-01-27

Note: Within the functional range the IC operates as described in the circuit description. The electrical

characteristics are specified within the conditions given in the related electrical characteristics table.

4.3

Default State of Inputs

Table 1

Default State of Inputs

to GND and the corresponding Sxx. The voltage is measured at the positive terminal of the C.

4.2.9

Voltage difference CB2-VDH

-0.3

25

V

Operation mode

4.2.10

Junction temperature

-40

150

°C

1) max ratings for Tj has to be considered as well

2) For proper start up minimum Vs=6.5V is required

3) Duty cycle is referred to the high side input command (IHx); The duty cycles can be driven continuously and fully operational

4) total current consumption from power net (Vs and VDH)

Pos.

Parameter

Symbol

Limit Values

Unit

Conditions

Min.

Max.

Characteristic

State

Remark

Default state of ILx (if ILx left open)

Low

Low side MOSFETs off

Default state of IHx (if IHx left open)

High

High side MOSFETs off

Default state of ENA (if ENA1 left open)

Low

Device outputs disabled

Default state of ENA (if ENA2 left open)

Low

Device outputs disabled

Default state of INH (if INH left open)

Low

(ISP=ISN=0V)

Zero ampere equivalent

–

Status of the device and the outputs when

ENA1=ENA2=INH='1'

Device active and outputs functional

Vs=5.5..28V

Pull up or pull down integrated resistors

Ixx, ENA

30k

–

Pull down integrated resistor INH

45k

–