REFERENCE DESIGN

IRMCS2011

This document is the property of International Rectifier and may not be copied or distributed without expressed consent.

6

ATTENTION: The IRMCS2011 system contains ESD (Electrostatic Discharge) sensitive

parts and assemblies. Static control precautions are required when installing, testing,

servicing or repairing this assembly. Component damage may result if ESD control

procedures are not followed. If you are not familiar with static control procedures, reference

applicable ESD protection handbook and guideline.

!

ATTENTION: An incorrectly applied or installed drive can result in component damage or

reduction in product life. Wiring or application errors such as undersizing the motor,

supplying an incorrect or inadequate AC supply, or excessive ambient temperatures may

result in system malfunction.

!

2.2 Unpacking and Inspecting

The IRMCS2011 system is shipped with packing materials that need to be removed prior to installation.

ATTENTION: Failure to remove all debris and packing materials, which are unnecessary

for system installation, may result in overheating or abnormal operating condition.

!

After unpacking, check the items. The following hardware pieces are contained in the IRMCS2011 system.

•

IRMCS2011 board with integrated heat sink

•

Serial RS232C cable with 9-pin D-sub connectors for ServoDesigner

•

Installation CD

Before you install and start up the system, check if there is any damaged component. In that case, stop proceeding and

contact our technical support.