STM32F411RET6 datasheet(22/149 Pages) STMICROELECTRONICS

22 / 149 page

Functional overview

STM32F411xC STM32F411xE

22/149

DocID026289 Rev 6

A comprehensive set of power-saving mode allows to design low-power applications.

When the internal reset is OFF, the following integrated features are no longer supported:

•

The integrated power-on reset (POR) / power-down reset (PDR) circuitry is disabled.

•

The brownout reset (BOR) circuitry must be disabled.

•

The embedded programmable voltage detector (PVD) is disabled.

•

VBAT functionality is no more available and VBAT pin should be connected to VDD.

3.16

Voltage regulator

The regulator has four operating modes:

•

Regulator ON

–

Main regulator mode (MR)

–

Low power regulator (LPR)

–

Power-down

•

Regulator OFF

3.16.1

Regulator ON

On packages embedding the BYPASS_REG pin, the regulator is enabled by holding

BYPASS_REG low. On all other packages, the regulator is always enabled.

There are three power modes configured by software when the regulator is ON:

•

MR is used in the nominal regulation mode (With different voltage scaling in Run)

In Main regulator mode (MR mode), different voltage scaling are provided to reach the

best compromise between maximum frequency and dynamic power consumption.

•

LPR is used in the Stop modes

The LP regulator mode is configured by software when entering Stop mode.

•

Power-down is used in Standby mode.

The Power-down mode is activated only when entering in Standby mode. The regulator

output is in high impedance and the kernel circuitry is powered down, inducing zero

consumption. The contents of the registers and SRAM are lost.

Depending on the package, one or two external ceramic capacitors should be connected on

the VCAP_1 and VCAP_2 pins. The VCAP_2 pin is only available for the LQFP100 and

UFBGA100 packages.

All packages have the regulator ON feature.

3.16.2

Regulator OFF

The Regulator OFF is available only on the UFBGA100, which features the BYPASS_REG

pin. The regulator is disabled by holding BYPASS_REG high. The regulator OFF mode

allows to supply externally a V12 voltage source through VCAP_1 and VCAP_2 pins.

Since the internal voltage scaling is not managed internally, the external voltage value must

be aligned with the targeted maximum frequency. Refer to Table 14: General operating

conditions.

The two 2.2 µF VCAP ceramic capacitors should be replaced by two 100 nF decoupling

capacitors. Refer to Figure 17: Power supply scheme.

STM32F411RET6 数据表(PDF) 22 Page - STMicroelectronics

STM32F411RET6 数据表(HTML) 22 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载