CS5532-AS datasheet(16/52 Pages) CIRRUS

16 / 52 page

CS5531/32/33/34

DS289PP5

ter can be manipulated by the user to mimic the

function of a DAC if desired.

2.2. Overview of ADC Register Structure

and Operating Modes

The CS5531/32/33/34 ADCs have an on-chip con-

troller, which includes a number of user-accessible

registers. The registers are used to hold offset and

gain calibration results, configure the chip's operat-

ing modes, hold conversion instructions, and to

store conversion data words. Figure 6 depicts a

block diagram of the on-chip controller’s internal

registers.

Each of the converters has 32-bit registers to func-

tion as offset and gain calibration registers for each

channel. The converters with two channels have

two offset and two gain calibration registers, the

converters with four channels have four offset and

four gain calibration registers. These registers hold

calibration results. The contents of these registers

can be read or written by the user. This allows cal-

ibration data to be off-loaded into an external EE-

PROM. The user can also manipulate the contents

of these registers to modify the offset or the gain

slope of the converter.

The converters include a 32-bit configuration reg-

ister which is used for setting options such as the

power down modes, resetting the converter, short-

ing the analog inputs, and enabling diagnostic test

bits like the guard signal.

A group of registers, called Channel Setup Regis-

ters, are used to hold pre-loaded conversion in-

structions. Each channel setup register is 32 bits

long, and holds two 16-bit conversion instructions

referred to as Setups. Upon power up, these regis-

ters can be initialized by the system microcontrol-

ler with conversion instructions. The user can then

instruct the converter to perform single or multiple

conversions or calibrations with the converter in

the mode defined by one of these Setups.

Offset 1 (1 x 32)

Offset 2 (1 x 32)

Offset 3 (1 x 32)

Offset 4 (1 x 32)

Gain1(1 x 32)

Gain2(1 x 32)

Gain3(1 x 32)

Gain4(1 x 32)

Setup 1

(1 x 16)

Setup 2

(1 x 16)

Setup 4

(1 x 16)

Setup 6

(1 x 16)

Setup 8

(1 x 16)

Setup 3

(1 x 16)

Setup 5

(1 x 16)

Setup 7

(1 x 16)

Offset Registers (4 x 32)

Gain R egisters (4 x 32)

Channel Setup

Registers (4 x 32)

Conversion Data

Con figuration Register (1 x 32)

Power S ave Select

Reset System

Input Short

Guard Signal

Voltage Reference Select

Output Latch

Output Latch Select

Channel Select

Gain

Word Rate

Unipolar/Bipolar

Output Latch

Delay Time

Open Circuit Detect

SDI

SDO

SCLK

Com mand

Serial

Interface

Data (1 x 32)

Offset/Gain Select

Filter Rate Select

Offset/Gain Pointer

Figure 6. CS5531/32/33/34 Register Diagram

CS5532-AS 数据表(PDF) 16 Page - Cirrus Logic

CS5532-AS 数据表(HTML) 16 Page - Cirrus Logic

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52

数据表下载

链接网址

CS5532-AS 数据表(PDF) 16 Page - Cirrus Logic

CS5532-AS 数据表(HTML) 16 Page - Cirrus Logic

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52

数据表 下载

链接网址

数据表下载